- Abedi, M. ; Askari, R. ; Sepahi-Youmsi, J. Axisymmetric and three-dimensional flow simulation of a mixed compression supersonic air inlet. 2013 Heat Mass Tran. 49 1489-1501
Paper not yet in RePEc: Add citation now
- Chen, J.H. ; Yu, J.L. ; Qian, S.X. Subcooling control method for the adjustable ejector in the direct expansion solar assisted ejector-compression heat pump water heater. 2019 Appl Therm Eng. 148 662-673
Paper not yet in RePEc: Add citation now
- Chen, Z. ; Zhao, H.X. ; Kong, F.C. Synergistic effect of adjustable ejector structure and operating parameters in solar-driven ejector refrigeration system. 2023 Sol Energy. 250 295-311
Paper not yet in RePEc: Add citation now
Cheng, J.H. ; Cao, X. ; Shao, L.L. Performance evaluation of a novel heat pump system for drying with EVI-compressor driven precooling and reheating. 2023 Energy. 278 -
Dashtebayaz, M.D. ; Abadi, M.K. ; Asadi, M. Investigation of a new solar-wind energy-based heat pump dryer for food waste drying based on different weather conditions. 2024 Energy. 290 -
- Dong, J.M. ; Yu, M.Q. ; Wang, W.N. Experimental investigation on low-temperature thermal energy driven steam ejector refrigeration system for cooling application. 2017 Appl Therm Eng. 123 167-176
Paper not yet in RePEc: Add citation now
- Galindo, J. ; Dolz, V. ; Tiseira, A. Numerical assessment of the dynamic behavior of a solar-driven jet-ejector refrigeration system equipped with an adjustable jet-ejector. 2021 Int J Refrig. 121 168-182
Paper not yet in RePEc: Add citation now
- Gu, W.D. ; Wang, X.L. ; Wang, L. Performance investigation of an auto-tuning area ratio ejector for MED-TVC desalination system. 2019 Appl Therm Eng. 155 470-479
Paper not yet in RePEc: Add citation now
Han, Y. ; Wang, X.D. ; Sun, H. CFD simulation on the boundary layer separation in the steam ejector and its influence on the pumping performance. 2019 Energy. 167 469-483
- He, Y. ; Deng, J.Q. ; Li, T.F. A numerical contrast on the adjustable and fixed transcritical CO2 ejector using exergy flux distribution analysis. 2019 Energ. Convers. Manage.. 196 729-738
Paper not yet in RePEc: Add citation now
- Huang, Y.L. ; Jiang, P.X. ; Zhu, Y.H. Shape optimization and flow irreversibility mechanism analysis of normal temperature, high temperature and wet stream ejectors. 2024 Appl Therm Eng. 242 -
Paper not yet in RePEc: Add citation now
Jing, S.Q. ; Chen, Q. ; Yu, J.L. Analysis of an ejector-assisted flash tank vapor injection heat pump cycle with dual evaporators for dryer application. 2024 Energy. 286 -
- Kazem, H.A. ; Chaichan, M.T. ; Al-Waeli, A.H.A. A systematic review of photovoltaic/thermal applications in heat pumps systems. 2024 Sol Energy. 269 -
Paper not yet in RePEc: Add citation now
Khafaji, H.K. ; Shahsavand, A. ; Shooshtari, S.H.R. Simultaneous optimization of crude oil refinery vacuum distillation column and corresponding ejector system. 2024 Energy. 294 -
- Li, Z.Y. ; Xu, W.W. ; Liang, T. Experimental and numerical studies on the performance of supersonic multi-nozzle ejector. 2024 Appl Therm Eng. 242 -
Paper not yet in RePEc: Add citation now
Lin, C. ; Cai, W.J. ; Li, Y.Z. The characteristics of pressure recovery in an adjustable ejector multi-evaporator refrigeration system. 2012 Energy. 46 148-155
- Liu, F. ; Liu, H.L. ; Han, G.H. Numerical investigation on performances of a CO2 ejector containing partially miscible lubricant using heterogeneous modeling. 2024 Appl Therm Eng. 244 -
Paper not yet in RePEc: Add citation now
- Liu, F. ; Liu, H.L. ; Liu, Y. Transient numerical study of CO 2 two-phase flow in a needle adjustable ejector. 2023 Int J Heat Mass Tran. 214 -
Paper not yet in RePEc: Add citation now
- Menon, A. ; Stojceska, V. ; Tassou, S.A. A systematic review on the recent advances of the energy efficiency improvements in non-conventional food drying technologies. 2020 Trends Food Sci Technol. 100 67-76
Paper not yet in RePEc: Add citation now
Niu, L.L. ; Zhang, X.B. Comparison of the performance enhancement of vacuum ejector by means of structure optimization and bypass methods. 2024 Energy. 297 -
- Pianthong, K. ; Seehanam, W. ; Behnia, M. Investigation and improvement of ejector refrigeration system using computational fluid dynamics technique. 2007 Energ. Convers. Manage.. 48 2556-2564
Paper not yet in RePEc: Add citation now
Sarkar, J. Ejector enhanced vapor compression refrigeration and heat pump systems—a review. 2012 Renew. Sust. Energ. Rev.. 16 6647-6659
- Smirnov, N.N. ; Betelin, V.B. ; Nikitin, V.F. Accumulation of errors in numerical simulations of chemically reacting gas dynamics. 2015 Acta Astronaut. 117 338-355
Paper not yet in RePEc: Add citation now
Tang, Y.Z. ; Liu, Z.L. ; Shi, C. A novel steam ejector with pressure regulation to optimize the entrained flow passage for performance improvement in MED-TVC desalination system. 2018 Energy. 158 305-316
- Tavakoli, M. ; Ahmadabadi, M.N. ; Joulaei, A. Enhancing subsonic ejector performance by incorporating a fluidic oscillator as the primary nozzle: a numerical investigation. 2023 Int. J. Thermofluids. 20 -
Paper not yet in RePEc: Add citation now
- Wen, H.Q. ; Yan, J. Effect of mixing chamber length on ejector performance with fixed/varied area ratio under three operating conditions in refrigerated trucks. 2021 Appl Therm Eng. 197 -
Paper not yet in RePEc: Add citation now
- Xia, J.X. ; Wang, J.F. ; Lou, J.W. Thermodynamic, economic analysis and multi-objective optimization of an improved self-condensing transcritical CO2 Rankine cycle with two-stage ejector for low grade heat utilization. 2024 Energ. Convers. Manage.. 305 -
Paper not yet in RePEc: Add citation now
- Yan, J. ; Gao, H.P. ; Wang, Z. Three-dimensional numerical study on the effect of radius of the equal-area mixing chamber on auxiliary entraining of the two-stage ejector. 2023 Case Stud Therm Eng. 51 -
Paper not yet in RePEc: Add citation now
- Yan, J. ; Li, S.Y. ; Liu, Z. Numerical investigation on optimization of ejector primary nozzle geometries with fixed/varied nozzle exit position. 2020 Appl Therm Eng. 175 -
Paper not yet in RePEc: Add citation now
- Yang, Y. ; Wang, N. ; Ren, X.T. Research on similarity characteristics of critical states transferring of adjustable ejector. 2023 Int J Refrig. 148 64-74
Paper not yet in RePEc: Add citation now
- Yu, M.Q. ; Yu, J.L. Theoretical study of a modified ejector enhanced vapor injection heat pump cycle with hybrid solar-air source for dryer application. 2022 Sol Energy. 248 171-182
Paper not yet in RePEc: Add citation now
- Yu, M.Q. ; Yu, J.L. Thermodynamic analyses of a solar assisted ejector enhanced vapor injection cycle with subcooler for heat pump dryer application. 2022 Sol Energy. 232 376-387
Paper not yet in RePEc: Add citation now
- Yu, M.Q. ; Zou, L.G. ; Yu, J.L. Experimental investigation on the drying characteristics in a solar assisted ejector enhanced heat pump dryer system. 2024 Sol Energy. 267 -
Paper not yet in RePEc: Add citation now
- Zeng, H.X. ; Zhao, H.X. ; Zhang, H. Simulation study of key cross-sectional area dimensions of CO2 on performance ejector. 2024 Int J Refrig. 159 276-286
Paper not yet in RePEc: Add citation now
- Zhang, X.A. ; Zhang, H. ; Kong, F.C. Numerical simulation of blade-type adjustable steam ejector. 2024 Appl Therm Eng. 238 -
Paper not yet in RePEc: Add citation now
- Zhang, Z.Y. ; Feng, X. ; Tian, D.Z. Progress in ejector-expansion vapor compression refrigeration and heat pump systems. 2020 Energ. Convers. Manage.. 207 -
Paper not yet in RePEc: Add citation now
Zou, L.G. ; Liu, Y. ; Yu, M.Q. A review of solar assisted heat pump technology for drying applications. 2023 Energy. 283 -