Gurin Water Flosser manual
2 likes318 views
The document provides instructions for using and maintaining a professional rechargeable oral irrigator, including setup, operation modes, and cleaning procedures. It emphasizes the importance of using appropriate water temperatures and cleaning agents, while also detailing troubleshooting steps for common issues. Additionally, it advises on battery removal for recycling at the end of the device's life.
Gurin Water Flosser manual
- 1. Professinal Rechargeable Oral Irrigator
- 2. Use the oral irrigator 1. Attach nozzle onto the unit. (Fig. 3) 2. Open the water tank cap, hold the unit upright, fill the tank with water which temperature not exceed 104°F, then close the cap. (Fig. 4) 3. Or, take down the water tank from the unit, hold the tank upright, fill the tank with water which temperature not exceed 104°F, then attach the tank onto the unit. (Fig.5) 4. Press “Mode” key to select the mode you desired. During irrigating, you can change the working mode. Normal: for normal cleaning. Soft: for gentle cleaning of sensitive gums. Pulse: for cleaning and massaging the gums. (Fig. 6) 5. Hold the unit in an upright position with nozzle tip point toward your teeth. 6. Keep your mouth opened slightly so that the water can flow out. 7. Press “On/Off” key to start irrigating. (Fig. 7) 1). Position the water jet flow at a 90-degree angle to the teeth and gums 2). Move the water jet slowly along the teeth 3). Position the water jet along the gum line with the nozzle tip at a 90-degree angle to the gum tissue 4). Now clean between the teeth and around any braces, crowns or bridgework thoroughly. 8. Press “On/Off” key again to turn off the device once irrigating complete. Use only water or neutral cleaning agent to clean the device. Never use caustic or abrasive agents (e.g., vinegar or lime scale removers), since they may damage the device. Do not wash using hot water of over 122°F. Keep the device away from high temperature area and avoid direct sunlight. 3 4 After using the appliance (Fig. 8) 1. Open the water tank cap and dispose off the water in the tank. 2. Press “On/Off” key to turn on the unit, and drain the water inside the appliance. 3. Press “On/Off” key again to turn off the unit, and close the water tank cap. 4. Wipe the device with dry cloth. Maintenance Disposal 015 Printed in China The rechargeable battery inside your appliance is easy to remove for recycling. At the end of the product’s life and prior to disposal, please remove the rechargeable battery from Water tank cap Wipe off any grime and dirt with a cloth. Nozzle 1. Wash with water and wipe with soft cloth. 2 Replace the nozzle every 6 months. Water suction tube 1. Wash with water and wipe with soft cloth. 2. Do not bend, pull or twist the water suction tube. Tank 1. Wash with water and wipe with soft cloth. 2. Dry the tank when not using for a long period. Troubleshooting Problem Possible Cause Solution It does not work You’ve just purchased the product or it has been left unused for more than 3 months. The battery has reached the end of its lift cycle. Charge the unit for at least 8 hours. Contact service center for support. It only works for a few minutes even after charging How to use Charging the device(Fig. 2) 1. Insert the appliance plug securely into the appliance socket (make sure no liquid remaining inside the socket before insert the appliance plug). 2. Insert the charging adaptor securely into the power outlet. 3. The “CH” indicator blinks when the device is charging, and it will be steadily on after the device is full charged. Note: If the “CH” indicator is blinking during or after irrigating, that means the battery need to be recharged. An full recharging will take about 8 hours. Note: To prevent bacteria propagating, make sure there is no remaining water inside the unit. If you’re not going to use this appliance for long time, be sure wipe and dry the appliance ASAP before storing it. Note: There may be some liquid remaining inside the main appliance before use (tank, water suction tube, etc), this is the remaining distilled water that was used for the performance (water flow) test, so there are no health concerns. Main unit 1. Remove the dirt by wiping using a cloth with liquid soap and wipe off using a dry cloth. 2. Do not submerge the main unit in water to clean. 3. Dry after washing with water. Charging time was insufficient. Charge the unit for at least 8 hours. Water pressure is very low There is dirt stuck in the nozzle The nozzle is deformed Replace the nozzle There is dirt stuck in the filter Clean the filter Water does not come out The tank is empty Fill up tank The appliance is tilted too much while in use Use with the appliance in a vertical state the handle by following the instructions below. During below operation, be sure to protect your eyes, hands, fingers, and the surface on which you work. 1. Remove 3pcs rubber feet on the bottom the handle. 2. Insert a screwdriver into the slot located at the bottom of the handle and turn counterclockwise to release the bottom cap. 3. Pull out the batteries from the handle. If you have recycling questions, please contact your local waste management office. Address: 2522 Chambers Road, Suite 100 Tustin, CA-92780 Web: www.gurinproducts.com Iroams Network