Steri trac detection system 0
- 1. ChemDAQ Steri-Trac Toxic Gas Detection System ChemDAQ’s Steri‐Trac gas monitoring system provides the optimal solution for workplace safety assurance, providing protection from toxic gases Sensor Exchange Program for Reduced Operating Costs KEYBENEFITS • DAQ software provides trend analysis and provides early warning The unique modular design of the Steri-Trac eliminates the need for in-house calibration. Using the sensor exchange program (SXP) you can receive a factory calibrated sensor every 4 months which you swap on site in a matter of seconds. of a situation to enable maximum User friendly Interfaces protection Steri-trac’s fixed detectors are designed to be used with the DAQ system to display gas concentrations, trends and exposures. Using a traffic light LED alarm system, it’s easy to interpret gas exposure in each area. • Sensor change out reduces downtime and costs Flexibility and Investment Protection • Modular design for custom configuration meets facilities specific needs • ChemDAQs chemical filter eliminates ETO H2O2 Mounted at entrance ways into areas where toxic gases are used or stored, it duplicates gas readings and alarms from its companion area detector, providing indication that it’s safe prior to entrance “ The only fixed detector to monitor Peracetic acid accurately at ppm levels “ GASESANALYSED O3 Take Personnel Protection to the Next Level nuisance alarms PAA The Steri-Trac toxic gas detector is a fully functioning, micro-processor controlled unit with tri-colour display and digital communications with the ability to report gas concentration in parts per million.
- 2. TECHNICALSPECIFICATION OUTPUTS GENERAL • Fixed detection of Ethylene Oxide, Hydrogen Peroxide & Oxide • Sample draw allows for EPA emissions of <1ppm / 24 hour • Single,. multi point or multi gas installations • Wide variety of applications including; pharmaceutical & hospitals, drinks manufacturing and bio-decontamination • Installation requirements: Wall mounted, 110 VAC, 1amp • Communications: Digital RS485 • External contact relays: 2 relays open/closed available • Monitors supported: Up to 8 as standard CERTIFICATIONS • Meets OSHA regulations for monitoring toxic gases: CFR 1910.1047, CFR 1910.1000 • Meets Canadian Standards Associations for monitoring toxic gases: CSA Z314.9-09 PHYSICAL • Meets OSHA record-keeping requirements 30 years of • Dimensions: 10” (W) x 6” (H) x 5” (D) • Display: Tricolour, 4 digit, 1.25”, 5 x 8 Matrix LED exposure data: CFR 1910.1020 • Meets the Joint Comission Standard EC 02.02.01 and AAMI ST:41/2005 recommendations PERFORMANCE • Alarms: 2 - User adjustable alarm levels, HIGH & LOW • Output: Linear • Calibration intervals: 4 months (factory calibrated) MEASURINGRANGES Ethylene Oxide Hydrogen Peroxide Ozone Peracetic Acid Resolution (ppm) 0.1ppm 0.1 ppm 0.002ppm 0-0.1ppm Sensor range 0-50ppm 0-10 ppm 0-5ppm 0-3ppm Response time < 140 sec (T90) < 150 sec (T90) < 150 sec (T90) Temperature / humidity -20 to 50oc 15 to 95% non-condensing 0 to 50oc 15 to 95% non-condensing -20 to + 50oc 15 to 95% non-condensing 11 Ark Royal Way, Lairdside Technology Park, Tranmere, Wirral, CH41 9HT T: +44(0)151 666 8300 F: +44(0)151 666 8329 E: sales@a1-cbiss.com W: www.a1-cbiss.com Buy Online: shop.a1-cbiss.com Cert No. 996 ISO 9001