ppt of BE
Download as PPT, PDF9 likes3,424 views
This document provides an overview of types of antennas and propagation modes. It discusses how antennas work to transmit and receive radio waves, and describes common types of antennas including omnidirectional antennas that radiate in all directions and directional antennas that preferentially radiate in a particular direction. It also summarizes the three main propagation modes: ground waves that hug the Earth's surface, space waves that travel in straight lines, and sky waves that reflect off the ionosphere. Key factors that determine the propagation path are frequency, atmospheric conditions, and time of day.
ppt of BE
- 1. Presentation on Types of antenna and Types of propagation Types of antenna and Types of propagation In partial fulfillment of the subject Basic Electronics (2110016) Submitted by : Akabari Nirali /130120116002 / IT Tinkle Kapadiya /130120116030 / IT Bhut Vidhi / 130120116013 / IT GANDHINAGAR INSTITUTE OF TECHNOLOGY
- 2. INTRODUCTION An antenna is an electrical device which converts electric currents into radio waves, and vice versa. It is usually used with a radio transmitter or radio receiver. In transmission, a radio transmitter applies an oscillating radio frequency electric current to the antenna's terminals, and the antenna radiates the energy from the current as electromagnetic waves (radio waves).
- 3. Transmitting Antenna: Any structure designed to efficiently radiate electromagnetic radiation in a preferred direction is called a transmitting antenna. In reception, an antenna intercepts some of the power of an electromagnetic wave in order to produce a tiny voltage at its terminals, that is applied to a receiver to be amplified. An antenna can be used for both transmitting and receiving. Receiving Antenna: Any structure designed to efficiently receive electromagnetic radiation is called a receiving antenna
- 4. WHERE USED? Antennas are used in systems such as radio and television broadcasting, point to point radio communication, wireless LAN, radar and space exploration. Antennas are most utilized in air or outer space. But can also be operated under water or even through soil and rock at certain frequencies for short distances.
- 5. TYPES OF ANTENNAS • According to their applications and technology available, antennas generally fall in one of two categories: 1.Omnidirectional or only weakly directional antennas which receive or radiate more or less in all directions. These are employed when the relative position of the other station is unknown or arbitrary. They are also used at lower frequencies where a directional antenna would be too large, or simply to cut costs in applications where a directional antenna isn't required. 2.Directional or beam antennas which are intended to preferentially radiate or receive in a particular direction or directional pattern.
- 6. • According to length of transmission lines available, antennas generally fall in one of two categories: 1.Resonant Antennas – is a transmission line, the length of which is exactly equal to multiples of half wavelength and it is open at both ends. 2.Non-resonant Antennas – the length of these antennas is not equal to exact multiples of half wavelength. In these antennas standing waves are not present as antennas are terminated in correct impedance which avoid reflections. The waves travel only in forward direction .Non-resonant antenna is a unidirectional antenna.
- 7. RADIATION PATTERN Radiation pattern of Typical Antennas
- 8. • The radiation pattern of an antenna is a plot of the relative field strength of the radio waves emitted by the antenna at different angles. • It is typically represented by a three dimensional graph, or polar plots of the horizontal and vertical cross sections. It is a plot of field strength in V/m versus the angle in degrees. • The pattern of an ideal isotropic antenna , which radiates equally in all directions, would look like a sphere. • Many non-directional antennas, such as dipoles, emit equal power in all horizontal directions, with the power dropping off at higher and lower angles; this is called an omni directional pattern and when plotted looks like a donut.
- 9. • The radiation of many antennas shows a pattern of maxima or "lobes" at various angles, separated by “nulls", angles where the radiation falls to zero. • This is because the radio waves emitted by different parts of the antenna typically interfere, causing maxima at angles where the radio waves arrive at distant points in phase, and zero radiation at other angles where the radio waves arrive out of phase. • In a directional antenna designed to project radio waves in a particular direction, the lobe in that direction is designed larger than the others and is called the "main lobe". • The other lobes usually represent unwanted radiation and are called “side lobes". The axis through the main lobe is called the "principle axis" or “bore sight axis".
- 10. ANTENNA GAIN Gain is a parameter which measures the degree of directivity of the antenna's radiation pattern. A high- gain antenna will preferentially radiate in a particular direction. Specifically, the antenna gain, or power gain of an antenna is defined as the ratio of the intensity (power per unit surface) radiated by the antenna in the direction of its maximum output, at an arbitrary distance, divided by the intensity radiated at the same distance by a hypothetical isotropic antenna.
- 11. The gain of an antenna is a passive phenomenon - power is not added by the antenna, but simply redistributed to provide more radiated power in a certain direction than would be transmitted by an isotropic antenna. High-gain antennas have the advantage of longer range and better signal quality, but must be aimed carefully in a particular direction. Low-gain antennas have shorter range, but the orientation of the antenna is relatively inconsequential.
- 12. POLARIZATION • The polarization of an antenna is the orientation of the electric field (E-plane) of the radio wave with respect to the Earth's surface and is determined by the physical structure of the antenna and by its orientation. • A simple straight wire antenna will have one polarization when mounted vertically, and a different polarization when mounted horizontally. • Reflections generally affect polarization. For radio waves the most important reflector is the ionosphere - signals which reflect from it will have their polarization changed • LF,VLF and MF antennas are vertically polarized
- 13. ANTENNA APPLICATIONS They are used in systems such as Radio broadcasting Broadcast television Two-way radio Communication receivers Radar Cell phones Satellite communications.
- 14. ANTENNA CONSIDERATIONS The space available for an antenna The proximity to neighbors The operating frequencies The output power Money
- 15. The three possible modes in which an EM wave can propagate through space are as follows : 1. Ground wave propagation 2. Sky wave propagation 3. Space wave propagation Once the signal leaves the antenna, it can take any of the following three routes. 15 Modes of Propagation of EM Waves :
- 16. The type of propagation is decided by the route taken by the signal to reach the receiver from the transmitter. The three basic paths that a radio signal take are : 1. Along the surface of the earth ( ground wave propagation) 2. Upto the layer called “ionosphere” and back ( sky wave propagation) 3. From transmitter to receiver in a straight line ( space wave propagation) The path taken by a radio signal depends on many factors including the frequency of the signal, atmospheric conditions and the time of day.
- 17. 1) Ground or Surface wave: • affected by natural and man-made terrain • salt water forms low loss path • several hundred mile range • 2-3 MHz signal • The ground or wave leaves the antenna and remains closed to the earth. • The ground wave will actually follow the curvature of the earth and therefore can travel a distance beyond the horizon. • The ground waves must be vertically polarized to prevent short circuiting of the electric field component.
- 18. 2) Space Wave • Line of Sight (LOS) wave • Ground Diffraction allows for greater distance • Approximate Maximum Distance, D in miles is D = (antenna height in ft) • No Strict Signal Frequency Limitations • The sky wave propagation cannot take place above the frequencies of 30 MHz because the ionosphere cannot reflect back such high frequencies and the ground wave dies out near the transmitting antenna itself, due to the wave front tilting. rxtx hh 22 + hrx htx
- 19. 3. Sky Waves • reflected off ionosphere (20-250 miles high) • large ranges possible with single hop or multi-hop • transmit angle affects distance, coverage, refracted energy ionosphere transmitted wave reflected wave refracted wave skip distance
- 20. In sky wave propagation, the transmitted signal travels into the upper atmosphere where it is bent or reflected back to earth. This bending or reflection of the signal take place due to the presence of a layer called as ionosphere in the upper atmosphere. Sky wave propagation is preffered for the short wave (SW) band of frequencies ( 3 MHz – 30 MHz).
- 21. Ionosphere • It is a layer of partially ionized gasses below troposphere - ionization caused by ultra-violet radiation from the sun - affected by: available sunlight, season - free ions & electrons reflect radiated energy • consists of several ionized layers with varying ion density - each layer has a central region of dense ionization Layer altitude (miles) Frequency Range Availability D 20-25 several MHz day only E 55-90 20MHz day, partially at night F1 90-140 30MHz 24 hours F2 200-250 30MHz 24 hours F & F separate during daylight, merge at night
- 22. Thank You