1703_anusua_basuclassful addressing_IP_Addressing
- 1. IP Addresses:- Classful Addressing Presented by:-ANUSUA BASU BCA_3rd_Semester Roll_No:-1703
- 2. Introduction Notations Classful addressing Class A Class B Class C Class D Class E o Subnetting o Disadvantages of classful addressing
- 3. Introduction IP address, or Internet Address 32-bit binary address Uniquely and universally defines the connection of a host or a router to the Internet Address Space Total number of addresses used by the protocol IPv4 uses 32-bit address and the address space is 2^32
- 4. If a protocol uses N bits to define an address, the address space is 2^N because each bit can have two different values (0 and 1) and N bits can have 2^N values. The address space of IPv4 is 2^32 or 4,294,967,296.
- 5. Binary notation Dotted-decimal notation Hexadecimal notation
- 6. 01110101 10010101 00011101 11101010
- 7. 1. The value of any segment (byte) is between 0 and 255 (both included). 2. There are no zeroes preceding the value in any segment (054 is wrong, 54 is correct).
- 9. Example 1:- Change the following IP address from dotted-decimal notation to binary notation. 111.56.45.78 Solution:- 01101111 01101111 00111000 00101101 Example 2:- Find the error, if any, in the following IP address: 111.56.045.78 Solution:- There are no leading zeroes in dotted-decimal notation (045). Example 3:- Find the error, if any, in the following IP address: 75.45.301.14 Solution:- In dotted-decimal notation, each number is less than or equal to 255; 301 is outside this range. Example 4:-Find the error, if any, in the following IP address: 11100010.23.14.67 Solution:- A mixture of binary notation and dotted decimal notation is not allowed.
- 10. The 32bit IP address space is divided into five classes: A, B, C, D, E Class A Class B Class C Class D Class E
- 11. Each of these classes has a valid range of IP addresses. Classes D and E are reserved for multicast and experimental purposes respectively. The order of bits in the first octet determine the classes of IP address. IPv4 address is divided into two parts: • Network ID • Host ID The class of IP address is used to determine the bits used for network ID and host ID and the number of total networks and hosts possible in that particular class. Each ISP or network administrator assigns IP address to each device that is connected to its network.
- 12. Note: IP addresses are globally managed by Internet Assigned Numbers Authority(IANA) and regional Internet registries(RIR). Note: While finding the total number of host IP addresses, 2 IP addresses are not counted and are therefore, decreased from the total count because the first IP address of any network is the network number and whereas the last IP address is reserved for broadcast IP.
- 13. IP address belonging to class A are assigned to the networks that contain a large number of hosts. •The network ID is 8 bits long. •The host ID is 24 bits long. The higher order bit of the first octet in class A is always set to 0. The remaining 7 bits in first octet are used to determine network ID. The 24 bits of host ID are used to determine the host in any network. The default subnet mask for class A is 255.x.x.x. Therefore, class A has a total of: •2^7-2= 126 network ID(Here 2 address is subtracted because 0.0.0.0 and 127.x.y.z are special address. ) •2^24 – 2 = 16,777,214 host ID(2address is subtracted because x.0.0.0 is used for Network id and x.255.255.255 is used for broadcast address). IP addresses belonging to class A ranges from 1.x.x.x – 126.x.x.x
- 14. Given the address 23.56.7.91 and the default class A mask, find the beginning address (network address). Solution:-The default mask is 255.0.0.0, which means that only the first byte is preserved and the other 3 bytes are set to 0s. The network address is 23.0.0.0.
- 15. IP address belonging to class B are assigned to the networks that ranges from medium-sized to large-sized networks. • The network ID is 16 bits long. • The host ID is 16 bits long. The higher order bits of the first octet of IP addresses of class B are always set to 10. The remaining 14 bits are used to determine network ID. The 16 bits of host ID is used to determine the host in any network. The default sub-net mask for class B is 255.255.x.x. Class B has a total of: • 2^14 = 16384 network address • 2^16 – 2 = 65534 host address IP addresses belonging to class B ranges from 128.0.x.x – 191.255.x.x.
- 16. Given the address 132.6.17.85 and the default class B mask, find the beginning address (network address). Solution:- The default mask is 255.255.0.0, which means that the first 2 bytes are preserved and the other 2 bytes are set to 0s. The network address is 132.6.0.0.
- 17. IP address belonging to class C are assigned to small-sized networks. • The network ID is 24 bits long. • The host ID is 8 bits long. The higher order bits of the first octet of IP addresses of class C are always set to 110. The remaining 21 bits are used to determine network ID. The 8 bits of host ID is used to determine the host in any network. The default sub-net mask for class C is 255.255.255.x. Class C has a total of: • 2^21 = 2097152 network address • 2^8 – 2 = 254 host address IP addresses belonging to class C ranges from 192.0.0.x – 223.255.255.x.
- 18. Given the address 201.180.56.5 and the class C default mask, find the beginning address (network address). Solution:- The default mask is 255.255.255.0, which means that the first 3 bytes are preserved and the last byte is set to 0. The network address is 201.180.56.0.
- 19. IP address belonging to class D are reserved for multi-casting. The higher order bits of the first octet of IP addresses belonging to class D are always set to 1110. The remaining bits are for the address that interested hosts recognize. Class D does not posses any sub-net mask. IP addresses belonging to class D ranges from 224.0.0.0 – 239.255.255.255. Reserved for multicasting or Group emailing.
- 20. IP addresses belonging to class E are reserved for experimental and research purposes. IP addresses of class E ranges from 240.0.0.0 – 255.255.255.254. This class doesn’t have any sub-net mask. The higher order bits of first octet of class E are always set to 1111. Reserved for military purpose.
- 22. IP Address=201.20.30.40 i. Which class does it belong to? Class C(range 192-223) i. Calculate the network id? 201.20.30.0(Default mask for Class C 255.255.255.0) i. Calculate the 4th host id? 201.20.30.4 i. Calculate the last host id? => 201.20.30.254
- 23. When a bigger network is divided into smaller networks, in order to maintain security, then that is known as Subnetting. so, maintenance is easier for smaller networks. Now, let’s talk about dividing a network into two parts: so to divide a network into two parts, you need to choose one bit for each Subnet from the host ID part. In the bellow diagram, there are two Subnets. Note: It is a class C IP so, there are 24 bits in the network id part and 8 bits in the host id part.
- 24. For Subnet-1: The first bit which is chosen from the host id part is zero and the range will be from (193.1.2.00000000 till you get all 1’s in the host ID part i.e, 193.1.2.01111111) except for the first bit which is chosen zero for subnet id part.Thus, the range of subnet-1: 193.1.2.0 to 193.1.2.127(193.1.2.0 is used for Subn1_id & 193.1.2.255 is used for Subn1_Broadcast id) For Subnet-2: The first bit chosen from the host id part is one and the range will be from (193.1.2.100000000 till you get all 1’s in the host ID part i.e, 193.1.2.11111111).Thus, the range of subnet-2: 193.1.2.128 to 193.1.2.255(193.1.2.128 is used for Subn2_id & 193.1.2.255 is uses for Subn2_broadcast_id) 1. To divide a network into four (22) parts you need to choose two bits from host id part for each subnet i.e, (00, 01, 10, 11). 2. To divide a network into eight (23) parts you need to choose three bits from host id part for each subnet i.e, (000, 001, 010, 011, 100, 101, 110, 111) and so on.
- 26. The problem with this classful addressing method is that millions of class A address are wasted, many of the class B address are wasted, whereas, number of addresses available in class C is so small that it cannot cater the needs of organizations. Class D addresses are used for multicast routing and are therefore available as a single block only. Class E addresses are reserved. Since there are these problems, Classful networking was replaced by Classless Inter-Domain Routing (CIDR) in 1993.
- 27. Geeksforgeeks Javatpoint Behrouz A. Forouzan