Acn Experiment No 3
Download as DOC, PDF0 likes567 views
Using basic commands of network simulation, we can: 1) Enter enable mode by pressing enter at the router console to enable commands, typing "enable", and entering the enable prompt. 2) View the OS version, memory, and RAM using the "show version" command in user mode where files can be viewed but not edited. 3) Open configuration mode using "configure terminal" to configure interfaces like serial or Ethernet ports by specifying the interface name and assigning an IP address, subnet mask, and bringing the interface up with "no shutdown".
Acn Experiment No 3
- 1. EXPERIMENT NO 3 Using Basic Commands of network simulation When we double click a router a console appear. On pressing enter we enable the USER prompt. Now we write command ENABLE and press enter to enter ENABLE prompt.
- 2. Router> Router>enable Router # In User mode all files are available but editing of these files is not possible. #show version : This command gives which version of OS ,memory,RAM,etc #configure terminal : For opening configuration mode. (config)# interface S0/0/0 : Is used for configuring any interface. We can configure serial interface as well as fast Ethernet interface using the command. (config-if)# ip address <ipaddr> <subnet mask> : Is used to assign ip address and subnet mask to the interface (config-if)# no shutdown : to make network up as by default it is down. (config-if)# exit : To exit and configure another interface