Bca 2nd sem-u-1.4 digital logic circuits, digital component

8085 Microprocessor Architecture
Course: BCA-2nd Sem
Subject: Introduction to
Microprocessor
Unit-2
1

1) Combinational
2) Sequential
• Combinational logic circuits (circuits without a
memory):
Combinational switching networks whose outputs
depend only on the current inputs.
• Sequential logic circuits (circuits with memory):
In this kind of network, the outputs depend on the
current inputs and the previous inputs. These
networks employ storage elements and logic
gates.
LOGIC CIRCUITS

COMBINATIONAL CIRCUITS[1]
• Most important standard combinational circuits are:
• Adders
• Subtractors
• Comparators
• Decoders
• Encoders
• Multiplexers
Available in IC’s as MSI and used as
standard cells in complex VLSI (ASIC)

ANALYSIS OF COMBINATIONAL
LOGIC[1]

ANALYSIS OF COMBINATIONAL
LOGIC

DESIGN OF COMBINATIONAL
LOGIC
1. From the specifications of the circuit,
determine the number of inputs and outputs
2. Derive the truth table that defines the
relationship between the input and the output.
3. Obtain the simplified Boolean function using
x-variable K-Map.
4. Draw the logic diagram and verify the
correctness of the design.

DESIGN OF COMBINATIONAL
LOGIC[2]
• Example: Design a combinational circuit with
three inputs and one output. The output is a 1
when the binary value is less than three.
• The output is 0 otherwise.

BINARY ADDER – Half Adder[2]
Implementation of Half Adder

Implementation Full Adder with two
half Adders[2]

4-BIT FULLADDER[2]
4 bit Adder

Magnitude Comparator
• A magnitude comparator is a combinational circuit that
compares two numbers, A and B, and then determines their
relative magnitudes.
 A > B
 A = B
 A < B
• Algorithm Consider two numbers, A and B, with four digits
each:
 A=A3 A2 A1 A0
 B=B3 B2 B1 B0
• xi=1 if A=B=0 or A=B=1
• xi=AiBi+ Ai’Bi’for i=0,1,2,3 XNOR
• For equality to exist, all xi variables must be equal to 1:
• (A=B)=X3 X2 X1 X0
AND Operation

Magnitude Comparator
• To determine if A is greater than or less than
B, we inspect the relative magnitudes of
significant digits.
• If the two digits are equal, we compare the
next lower significant pair of digits. The
comparison continues until a pair of unequal
digits is reached.
• The sequential comparison can be expressed
by:

DECODERS
• A decoder is a combinational circuit that converts
binary information
• from n input lines to an 2nunique output lines.
• Some Applications:
a) Microprocessor memory system: selecting different
banks of memory.
b) Microprocessor I/O: Selecting different devices.
c) Memory: Decoding memory addresses (e.g. in ROM).
d) Decoding the binary input to activate the LED
segments so that the decimal number can be
displayed.

3-to-8-line DECODER[3]
• If the input corresponds to minterm mi then the
decoder ouput i will be the single asserted
output.

2-to-4-line DECODER with
Enable[3]
• The decoder is enabled when E = 0. The output whose
value = 0 represents the minterm is selected by inputs
A and B.
• The decoder is inactive when E=1 D0………D3 =1
• A Decoder with enable input is called a
decoder/demultiplexer. Demultiplexer receives
information from a single line and directs it to the
output lines.

A 4 x 16 DECODER[3]
• When w = 0, the top decoder is enabled and the bottom is
disabled.
• Top decoder generates 8 minterms 0000 to 0111, while the
bottom decoder outputs are 0’s.
• When w = 1, the top decoder is disabled and the bottom is
enabled.
• Bottom decoder generates 8 minterms 1000 to 1111, while
the top decoder outputs are 0’s.

MULTIPLEXERS/DATA
SELECTORS[4]
• A multiplexer is a combinational circuit that
selects one of many input lines (2n ) and steers
it to its single output line. There are (2n ) and n
selection lines whose bit combinations
determine which input is selected.

4-to-1LINE MULTIPLEXER
DESIGN[4]
• In general, a 2n –to–1- line multiplexer is
constructed from an n–to 2n decoder by adding
to 2n it lines, one to each AND gate.

References
1. Computer Organization and Architecture, Designing
for performance by William Stallings, Prentice Hall
of India.
2. Modern Computer Architecture, by Morris Mano,
Prentice Hall of India.
3. Computer Architecture and Organization by John P.
Hayes, McGraw Hill Publishing Company.
4. Computer Organization by V. Carl Hamacher,
Zvonko G. Vranesic, Safwat G. Zaky, McGraw Hill
Publishing Company.

Bca 2nd sem-u-1.4 digital logic circuits, digital component

More Related Content

What's hot (20)

Similar to Bca 2nd sem-u-1.4 digital logic circuits, digital component (20)

More from Rai University (20)

Recently uploaded (20)

Bca 2nd sem-u-1.4 digital logic circuits, digital component