Bicycle indicator
- 1. circuit ideas Bicycle Indicator edi s.c. dwiv T.K. Hareendran the square-wave oscillators (one built around T1 and T2 and the other built T he electronic bicycle signaling around T3 and T4) drive four red LEDs unit described here uses low- (LED1 and LED2, and LED5 and LED6, determined by timing capacitors C1 cost components and is a good respectively), which blink to indicate and C2. Resistors R2 and R3 limit the operating current of LEDs (LED1 and LED2). At the same time, the green LED (LED3) starts glowing to indicate the present direction status. Similar action happens in the next oscillator circuit built around transistors T3 and T4 when switch S2 is flipped to ‘on’ position. Indi- cators at the front right (FR) and rear right (RR) start blinking, and at the same time the green LED (LED4) glows to indicate the direc- tion status. Switch S3 is used for emergency indication. When it is flipped to ‘on’ position, both the oscillators get power supply through diodes D1 and D2. As a result, LED1 through Fig. 1: Circuit of bi-cycle indicator LED6 start working simultaneous- ly. In this condition, all the LEDs blink, except LED3 and LED4, which glow steadily. After assembling the circuit on a general- purpose PCB, enclose it in a suitable cabinet as shown in Fig. 2 and mount on the handle bar of the bicycle, pref- Fig. 3: Suggested enclosure (indicators) erably at the mechani- cal centre point. Con- the direction of turn. Ad- nect switch S1 at the left-hand side, S2 ditional steady-glow LEDs at the right-hand side and emergency (LED3 and LED4) are in- switch S3 in the middle of the master corporated to indicate the unit. Now place this master unit at Fig. 2: Suggested enclosure (master unit) working status. the top of the handle bar and do the substitute to many commercially avail- The working of the cir- essential interconnections using flex- able versions. It works in an extremely cuit is straightforward. When ible wires. Connect the front indica- different manner and is convenient to switch S1 is flipped to ‘on’ po- tors (LED1 and LED5) to the left and operate. sition, DC supply from right side of the handle and similarly The circuit works off a 9V PP3 the battery is extended to the oscil- rear indicators (LED2 and LED6) can (alkaline-type) battery and is basically lator circuit formed by transistors be mounted in the carrier frame of a set of two independent free-running T1 and T2. Now the left-side oscil- the bicycle. For the direction indica- oscillators (astable multivibrators) built lator starts oscillating and the visual tor, you can use the symbol shown in around four low-power transistors indicators at the front left (FL) and Fig. 3 and place it at the centre of the and a few passive components. Both rear left (RL) start blinking at a rate handle. w w w. e f y m ag . co m e l e c t ro n i c s f o r yo u • j u ly 2 0 0 8 • 9 5