Biofeedback Using BPM and HRV Values

Spooky2
Our Users & Team
Biofeedback Using BPM and HRV Values

Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
When we use a biofeedback scan, we are asking the body to tell us
what it needs. The body knows well and does not lie. However, when
we try to force the body to go in a direction we want, well this just
does not usually work out well.
While we can isolate the results to known modalities, one would be
hard pressed to scan with only one result in mind.

You can't really tell your body to ignore all the things you maybe don't
even know about, in favor of that one frequency that will make your left
toe stop itching.
Lots of times things get complicated by the fact we try to treat based
on symptoms and not the source. When doing a biofeedback scan, the
body knows the source and will respond accordingly.

With that in mind, one should use the frequencies as is in a treatment. I often see that
someone believes they need to use the information to select frequency sets to run. The
best frequency set was already given.
With that said, we can filter the results the body returns into specific modalities.
When we scan for Max BPM, we are only finding frequencies that elicit a maximum stress
event. Therefore, all results will be of a killing modality.

When we scan for Min BPM, we are only finding frequencies that elicit a calming event,
therefore of a healing modality.
When we scan using Max HRV, we are finding frequencies that elicit the maximum
stress or calming event, as this is an absolute function. This means all frequency hits
returns can be for either modality, and there is no way to know for which.

When we scan using Min HRV, we are looking for frequencies that elicit the least
change to our body. Again this is an absolute function -- can find both types of
frequencies. Where this may be useful is if you are looking for frequencies for instance
that help maintain a steady state during meditation.
As for the frequency range.

76k to 152k is an octal range. 152 is twice that of 76. It is like scanning one octave of
the piano from Middle C to High C.
Every frequency is covered by harmonic resonance when you scan a range like this.
The low C, the lowest A, and the highest G on the piano are also tickled by resonance.

So the entire range can not be defined as a killing only range. While we do not have all
frequencies mapped out to make a claim like this on any range, when dealing with an
octal range (ending frequency is twice the starting frequency), you essentially are
covering all frequencies and thus the entire gambit.

The frequency is what does the work. Not the settings, not the preset.
So if you use the results from a Max BPM scan with the Healing preset, which uses a
square wave, it will still kill stuff.
If you ran it via the Killing preset, you would just aid the frequencies ability to kill by using
more appropriate settings.
You can not turn a frequency from one modality to another by switching presets or
waveforms.

Biofeedback Using BPM and HRV Values

More Related Content

Viewers also liked (6)

Similar to Biofeedback Using BPM and HRV Values (10)

More from Spooky2 Rife (20)

Recently uploaded (20)

Biofeedback Using BPM and HRV Values