Contactor
Download as PPTX, PDF0 likes190 views
A contactor is an electrically controlled switch used for switching electrical power circuits similar to a relay but with higher current ratings. It has three main components - contacts that carry the current, an electromagnet or coil that provides the driving force to close the contacts, and an insulating enclosure housing the contacts and coil. Contactors are designed to directly connect to high-current load devices above 15 amps, unlike relays which are lower capacity and can be normally open or closed. Modern contactors use techniques like vacuum or inert gases to suppress arcs between contacts during opening and closing to prevent damage.
Contactor
- 1. In semiconductor testing, contactor can also refer to the specialized socket that connects the device under test.In process industries a contactor is a vessel where two streams interact, for example, air and liquid. See Gas-liquid contactor. A contactor is an electrically controlled switch used for switching an electrical power circuit, similar to a relay except with higher current ratings
- 3. A contactor has three components. The contacts are the current carrying part of the contactor. This includes power contacts, auxiliary contacts, and contact springs. The electromagnet (or "coil") provides the driving force to close the contacts. The enclosure is a frame housing the contact and the electromagnet. Enclosures are made of insulating materials like Bakelite, Nylon 6, and thermosetting plastics to protect and insulate the contacts and to provide some measure of protection against personnel touching the contacts.
- 6. Unlike general-purpose relays, contactors are designed to be directly connected to high- current load devices. Relays tend to be of lower capacity and are usually designed for both normally closed and normally open applications. Devices switching more than 15 amperes or in circuits rated more than a few kilowatts are usually called contactors. Apart from optional auxiliary low current contacts, contactors are almost exclusively fitted with normally open ("form A") contacts.
- 11. Without adequate contact protection, the occurrence of electric current arcing causes significant degradation of the contacts, which suffer significant damage. An electrical arc occurs between the two contact points (electrodes) when they transition from a closed to an open (break arc) or from an open to a closed (make arc). The break arc is typically more energetic and thus more destructive.
- 12. Most motor control contactors at low voltages (600 volts and less) are air break contactors; air at atmospheric pressure surrounds the contacts and extinguishes the arc when interrupting the circuit. Modern medium-voltage AC motor controllers use vacuum contactors. High voltage AC contactors (greater than 1000 volts) may use vacuum or an inert gas around the contacts.
- 13. Contactors are rated by designed load current per contact (pole), maximum fault withstand current, duty cycle, design life expectancy, voltage, and coil voltage. A general purpose motor control contactor may be suitable for heavy starting duty on large motors; so- called "definite purpose" contactors are carefully adapted to such applications as air-conditioning compressor motor starting.
- 14. NEMA contactors for low-voltage motors (less than 1000 volts) are rated according to NEMA size, which gives a maximum continuous current rating and a rating by horsepower for attached induction motors. NEMA standard contactor sizes are designated 00,0,1,2,3,4,5,6,7,8,9
- 20. Vacuum contactors utilize vacuum bottle encapsulated contacts to suppress the arc. This arc suppression allows the contacts to be much smaller and use less space than air break contacts at higher currents. As the contacts are encapsulated, vacuum contactors are used fairly extensively in dirty applications, such as mining.
- 21. A mercury-wetted relay is a form of relay, usually a reed relay, in which the contacts are wetted with mercury. These are not considered contactors because they are not intended for currents above 15 amps.