E cwith scada
- 1. Gloabtel Convergence Ltd Energy Conserver For Lighting and Mixed Loads Welcomes You
- 2. Energy Conserver Cost Calculation for 100 Km Road Project On An Average for every 100 km one needs to Light up vide Flyover or Bridge, Truck Lay Bays & Toll Plazas at least 200 Kw Of Electricity. The cost of Electricity on Average from Electricity Board costs around Rs. 5.5 per Unit whereas same Energy Cost per Unit by Diesel Generated costs around Rs. 11.50. Now If one uses our Energy Conserver they are able to Save their lighting bill upto 25%. On An Average considering above facts For every 100 Km of NHAI BOT project the cost for Lighting is Rs. 3.96 Lacs Per Month i.e. Rs. 47.52 Lacs per Annum Considering Saving @ 25% on this Cost One Can Save their Energy Bill by Rs. 0.99 Lacs Per Month i.e. Rs. 11.88 Lacs per Annum
- 3. Why Energy Conservation? Kw / KwH reduction National Interest Green Environment Energy Conserver Suitable for? Suitable for Lighting Load comprising of all Gas discharge lamps such as Florescent, MV, S.V. Lamps etc. Mixed Load comprising of fluorescent tubes, CFL, MH, HVSV, HPMV, lamps and other discharge lamps and window or split air-conditioners, raw plug connected office equipments such as computers, fans, exhaust fans etc. Ideal for all types of industries, oil corporations, software companies, street lighting, control rooms, sub-stations, hotels, office buildings, hospitals etc .
- 4. Additional Benefits of Energy Conserver Extends the life of lamps Improves Power Factor Zero Electronics Over load protections provided Efficiency of equipment as high as 99% Return of investment below 1 year ( depending upon load and running hours ) No effect on line frequency No Harmonic Distortions Reduces temperature rise & heat loss in the circuit Maintenance free life of more than 20 years Any special requirement / specification can be adopted in the Panel.
- 5. WORKING PRINCIPLE EC is a high efficiency device, which optimizes the voltage (Static or dynamically) as the energy consumed increases in approximately square of input voltage, hence, the output energy would reach a minimum, beyond which the energy consumed will be wasted . The product works under the principle of current optimization by using a low loss impedance device in series with the electrical circuit which results in: • 15% - 25% savings in Lighting Load • 2% - 10% savings in A.C. Load • 8% - 15% savings in Mixed Load
- 6. Energy Conserver with SCADA System Panel 1 Panel 5 Panel 9 Panel 15 Panel 20 Panel 25
- 7. The Main CMU can be linked to n number of Panels which has Energy Meters with RS 485 These meters will be connected to our SCADA system which will have either GSM / GPRS technology to transfer the required datas to main CMU Main CMU Room of EC with SCADA From the main CMU you can control the panels like:- Switching On / Off In case of failure at any panel SMS to concern Engineer / Officer
- 8. a- At predetermined time the system will be switched ON and OFF. - YES b- The system will work at in coming voltage only whenever it is turned On from Off mode - YES c- At pre-determined time it will move to energy saver mode @25% but not bringing lumens lower than 50% considering incoming voltage to be 240 volts – YES d- In any case the power is shut off and equipment restarts it will re start at incoming voltage only and after 15 or 20 min only, it will go in energy saver mode (Provided the time is of energy saver mode) - YES e- At predetermined time the system will come back to full voltage and once again at predetermined time the system will be turned off - YES f- In any of above transmissions from By pass to Energy Saver mode and vice – versa their will be no flickering or momentarily black out of lumination – YES g- The process of transfer from By pass to Energy Saver and vice versa will be completely automatic and without any momentary lapse in illumination – YES h- The incomer will to be provided with energy meter having RS 232 / RS 485 and they will provide following parameters - YES 1. Volt, Amp, Kw KvA (phase, neutral) 2. KwH Energy Conserver with SCADA System
- 9. Different Reports available with EC (Scada): Hourly & Monthly- Monthly Energy reports / Panel Daily & Monthly- Monthly Energy reports/ Panel reports with specific energy Consumption (SEC) Monthly / Yearly Energy report / Panel GroupWise or Section wise all meters reports User defined time & date report TOD Report (5 slots with user defined timings) Daily log book- Area wise or Section wise Report of No Power Report for above set point * Reports can be customized as per need and details provided by customer
- 10. Sample of Report of EC with Scada
- 11. Sample of Report of EC with Scada
- 12. Sample of Report of EC with Scada
- 13. Sample of Report of EC with Scada
- 14. Screen shot of the Software Sample of Report of EC with Scada
- 15. Energy Conserver
- 16. Morakhia Group with turnover exceeding Rs. 120 Crores launched Gloabtel Convergence Ltd in year 2000 Gloabtel is professionally managed company involved in Conservation, Security and Monitoring . Gloabtel in past 9 years of existence has served various companies as diversified as L&T Cement (Ultra Tech), Nirma Industries, Gujarat Adani Energy Ltd, Welspun Plat & Pipe division, IFFCO , GNFC, Apollo Tyres, Suzlon Energy, Mayur Cooperative Dairy, Gujarat Glass P Ltd, United Phosphorus Ltd, Birla Copper, Micro Inks Ltd, Hindalco Industries, Alok Industries Ltd, Supreme Treves , Precision Wires Ltd, ONGC, TATA Automobiles, Mahindra Hinolay Motors , Chhattisgarh Electricity Board , Raymond India, Shyam Ferro Alloys Ltd , Corporate ISPAT, Goa State Electricity Board, Gujarat Electricity Board, etc…… Offices at – USA, Middle East, Mumbai, Ahmedabad. ISO 9001:2008 certified company from DNV Veritas COMPANY PROFILE
- 17. Soliciting your patronage for our Conservation, Security & Monitoring Range of Products Gloabtel Convergence Ltd. 190- G, R K Building, Khetwadi Main Road, Mumbai-04 Maneesh Tikku M- 09320738264 email- mtikku@gloabtel.com Tel - 022- 40426440