High Voltage Engineering unit 1, hight voltage.ppt
- 1. HIGH VOLTAGE ENGINEERING Presented By P.Sindhu Asst.Prof EEE Dept
- 2. OVER VOLTAGES IN ELECTRICAL POWER SYSTEMS
- 3. 3 LIGHTING Causes of over voltage Lightning phenomenon Charge formation of Lightning Rate of Charging of thunder cloud Mechanism of lightning strokes Characteristics of Lightning strokes
- 4. 4 LIGHTING Factors contributing to good line design Protection afforded by ground wires. Tower footing resistance Interaction between lightning and power system Mathematical model of Lightning
- 5. 5 Causes of Lightning Lightning phenomenon - peak discharge in which charge accumulated in the cloud into neighbouring cloud or to the ground Electrode separation – cloud to cloud or cloud to ground is about 10 km or more
- 6. 6 CHARGE FORMATION OF CLOUD Positive and negative charges become separated by heavy air current with ice crystals in the upper part and rain in the lower region. Charge separation depends on height of cloud (200 – 10,000m). Charge centers at a distance about 300 – 2km
- 7. 7 CHARGE FORMATION OF CLOUD Charge inside the cloud – 1 to 100 C Cloud potential – 107 to 108 V Gradient within a cloud – 100 V/cm Gradient at initial discharge point – 10kV/cm Energy at discharge – 250 kWhr
- 9. 9 MECHANISM OF LIGHTNING FLASH Pilot streamer and Stepped leader Ground streamer and return stroke Subsequent strokes
- 10. 10 PILOT STREAMER AND STEPPED LEADER
- 11. 11 GROUND STREAMER AND RETURN STROKE
- 12. 12 CHARACTERISTICS OF LIGHTNING STROKES Current-time characteristics Time to peak or Rate of rise Probability distribution of current and time Wave shapes of lightning voltage and current
- 13. 13 LIGHTNING CURRENT Short front time - 10µs Tail time – several ms.
- 14. 14 RATE OF RISE 50% lightning stroke current – greater than 7.5kA/µs. 10% lightning strokes current – exceeds 25 kA/µs. Stroke current above half value – more than 30µs.
- 15. 15 SURGE VOLTAGE Maximum surge voltage in transmission line – 5MV Most of the surge voltage is less than 1000 kV on line. Front time – 2 to 10 µs Tail time – 20 to 100 µs Rate of rise of voltage – 1MV/ µs
- 16. 16 LIGHTNING STROKES Direct stroke directly discharges on to transmission line or line wires Induced stroke cloud generates negative charge at its base, the earth object develop induced positive charge
- 17. 17 OVER VOLTAGE DUE TO SWITCHING SURGES INTRODUCTION In switching, the over voltage thus generated last for longer durations and therefore are severe and more dangerous to the system The switching over voltages depends on the normal voltage of the system and hence increase with increased system voltage
- 18. 18 ORIGIN OF SWITCHING SURGES Making and breaking of electric circuits with switchgear may results in abnormal over voltages in power systems having large inductances and capacitances. over voltages may go as high as 6 times the normal power frequency voltage.
- 19. 19 ORIGIN OF SWITCHING SURGES In circuit breaking operation switching surges with a high rate of rise of voltage may cause repeated restriking of the arc between the contacts of a circuit breaker, thereby causing destruction of the circuit breaker contacts. Switching surges may include high natural frequencies of the system, a damped normal frequency voltage component, or restriking and recovery voltage of the system with successive reflected waves from terminations.
- 20. 20 CHARACTERISTICS OF SWITCHING SURGES De-energizing of transmission lines, cables, shunt capacitor, banks, etc. Disconnection of unloaded transformers, reactors, etc. Energization or reclosing of lines and reactive loads. Sudden switching off of loads. Short circuit and fault clearances. Resonance phenomenon like ferro- resonance, arcing grounds, etc.
- 21. 21 CONTROL OF OVERVOLTAGES DUE TO SWITCHING Energization of transmission lines in one or more steps by inserting resistances and withdrawing them afterwards. Phase controlled closing of circuit breakers. Drainage of trapped charges before reclosing Use of shunt reactors. Limiting switching surges by suitable surge diverters.
- 22. 22 PROTECTION AGAINST OVERVOLTAGS Minimizing the lightning overvoltages are done by suitable line designs, Providing guard and ground wires, Using surge diverters.
- 23. 23 PROTECTION AGAINST OVERVOLTAGS Shielding the overhead lines by using ground wires above the phase wires, Using ground rods and counter- poise wires, Including protective devices like explosion gaps, protector tubes on the lines, and surge diverters at the line terminations and substations
- 24. Thank You 24