Installation and configuration of Wireless NIC
Download as PPTX, PDF3 likes2,196 views
The document outlines the steps to install a wireless NIC, including physically securing the component and configuring the necessary software. It emphasizes the importance of using stable, model-specific software to avoid connection issues. After installation, users can connect to Wi-Fi networks and confirm detection through the device manager.
Installation and configuration of Wireless NIC
- 1. Installation of Wireless NIC Ajay Jassi
- 2. Installing wireless NIC component 1. Firstly take out the wireless NIC from the packaging. 2. Secondly unclip the supporter lever for the expansion slots. 3. Then allocate the wireless NIC and apply little pressure to secure it in position. 4. Now push back down the supporter lever for security. 5. Finally screw on the antenna to the wireless NIC adapter.
- 4. After component installation After the component part is inserted and secured into the motherboard, it will need to be configured on the computer system. An software program will need to be installed, for the wireless NIC to operate and connect to an internet connection wirelessly. Its important that the software is a stable version and is made for the wireless NIC brand and model. If a unverified software is used it may not function probably and may change the configuration settings of an current connection. The model number of the wireless NIC should be printed on the component and on the original box/packaging.
- 6. Firstly put the installation disk into the DVD/CD drive.
- 7. Open up the disk to view files and click on the setup.
- 8. Once the setup is installed click on the specific model.
- 9. Configure to install the driver and software by clicking next.
- 10. Now it will give a option to download the driver or the driver with the utility software.
- 11. It will allow to change the file location, but is recommended to keep it in the C drive with the OS.
- 12. The installation will take place for about 2-3 minutes.
- 13. Once the setup is complete, just click finish and the utility will popup ready to connect.
- 15. Now connect Wi-Fi network to computer.
- 16. If you go to device manager, under the tab network adapters you will see that the device was detected.
- 17. The configuration utility will also be in the notification bar, for easier access.