PowerShell install Windows Feature
0 likes609 views
This document provides instructions for installing the Telnet Client feature in Windows using PowerShell. It describes importing the ServerManager module, checking the current installation status of Telnet Client, using Add-WindowsFeature to install it, and verifying the installation was successful by checking the status again.
PowerShell install Windows Feature
- 1. PowerShell – Install Telnet Client – Windows Feature i | P a g e Table of Contents Overview.......................................................................................................................................................1 Applies To......................................................................................................................................................1 Pre-requisites................................................................................................................................................1 Get Modules Available..............................................................................................................................1 Install Windows Feature – Telnet Client.......................................................................................................1 Install – Import Module ............................................................................................................................2 Install – Validate Installation Status..........................................................................................................2 Install – Add Windows Feature.................................................................................................................2 Install – Progress.......................................................................................................................................3 Install – Status...........................................................................................................................................3 List – All Windows Feature............................................................................................................................4
- 2. PowerShell – Install Telnet Client – Windows Feature 1 | P a g e Overview This guide will help in installing Windows Feature “Telnet Client” with PowerShell. Applies To Windows 2008, Windows 2008 R2 Pre-requisites Server Manager Module Get Modules Available List the modules available for the Operating system. To list the available modules, run the below command. Get-Module -ListAvailable Install – Telnet Client Installing Windows Feature with PowerShell in this guide we would be installing telnet-client for localhost.
- 3. PowerShell – Install Telnet Client – Windows Feature 2 | P a g e Install – Import Module From the available modules, import the module “ServerManager”, to import the module run the below command. Import-Module ServerManager Install – Validate Installation Status Before you install check if the “Telnet-Client” feature is installed or not. To check run the below command. Get-WindowsFeature –Name "telnet*" Note: In this case Feature “Telnet Client” is not installed. Install – Add Windows Feature After importing the server manager module; to install telnet client feature on the localhost, run the below command. Add-WindowsFeature Telnet-Client
- 4. PowerShell – Install Telnet Client – Windows Feature 3 | P a g e Install – Progress After executing the add windows feature command, progress bar will be displayed as shown below. Install – Status Upon successful installation windows feature; installation status is displayed as shown below. Additionally, you can run below command to check if installation is successful. Check mark will be marked against the installed windows feature. Get-WindowsFeature –Name "telnet*"
- 5. PowerShell – Install Telnet Client – Windows Feature 4 | P a g e List – All Windows Feature To list of all the windows feature on the specific operating system. Get-WindowsFeature