Topic 2 & 3 Pj
- 1. PJM 3106 ANATOMI DAN FISIOLOGI TAJUK 2 & 3 SISTEM RANGKA
- 2. INTRODUCTION The human body contains 206 bones organized into a structural framework called skeleton. The bones of the skeletal system are controlled by hundreds of muscles, which in turn are controlled by impulses from central nervous system
- 3. Anatomically, the skeleton is divided into two major sections. Axial Skeletal which is composed of bones of the body’s central axis (skull, vertebral column, the rib cage) 2. Apppendicular Skeleton which is composed of bones of the upper and lower appendages and bones attaching them to axial skeletal Articulation (Joints) The junctions where two or more bones come together
- 4. FUNCTIONS OF BONES Support Bones provide a hard framework that support the body and cradles its soft organs. For example, bones of lower limbs act as pillars to support the body trunk when we stand, and the rib cage support the thoracic wall Protection The fused bones of the skull provide a snug enclosure for the brain. The vertebrae surround the spinal cord, and rib cage helps protect the vital organs of the thorax
- 5. 3. Movement Skeletal muscles, which are attached to bones by tendons, use the bones as levers to move the body and its parts. As a result, we can walk, and breathe. The arrangement of bones and the design of joint determine the type of movement possible 4. Mineral Storage Bones serves as a reservoir for minerals, the most important of which are calcium and phosphate. The stored minerals can be realeased into the bloodstream as ions to distribution to all parts of the body as needed.
- 6. Indeed, ‘deposits’ and ‘withdrawal’ of minerals to and from the bones go on almost continuously 5. Blood cell formation The bulk of blood cell formation, or hematopoiesis, occur within the marrow cavities of certain bones .
- 7. CLASSIFICATIONS OF BONES The bones of the body come in a variety of sizes and shapes. The four principal types of bones are long, short, flat and irregular Long Bones Bones that are longer than they are wide are called long bones. They consist of a long shaft with two bulky ends or extremities. They are primarily compact bone but may have a large amount of spongy bone at the ends or extremities. Long bones include bones of the thigh, leg, arm, and forearm.
- 9. Short Bones Short bones are roughly cube shaped with vertical and horizontal dimensions approximately equal. They consist primarily of spongy bone, which is covered by a thin layer of compact bone. Short bones include the bones of the wrist and ankle. Flat Bones Flat bones are thin, flattened, and usually curved. Most of the bones of the cranium are flat bones.
- 10. Irregular Bones Bones that are not in any of the above three categories are classified as irregular bones. They are primarily spongy bone that is covered with a thin layer of compact bone. The vertebrae and some of the bones in the skull are irregular bones. All bones have surface markings and characteristics that make a specific bone unique. There are holes, depressions, smooth facets, lines, projections and other markings. These usually represent passageways for vessels and nerves, points of articulation with other bones or points of attachment for tendons and ligaments.
- 11. STRUCTURE OF BONES TISSUE There are two types of bone tissue: compact and spongy. The names imply that the two types of differ in density, or how tightly the tissue is packed together. There are three types of cells that contribute to bone homeostasis. Osteoblasts are bone-forming cell, osteoclasts resorb or break down bone, and osteocytes are mature bone cells. An equilibrium between osteoblasts and osteoclasts maintains bone tissue.
- 12. Compact Bones Compact bone consists of closely packed osteons or haversian systems. The osteon consists of a central canal called the osteonic (haversian) canal, which is surrounded by concentric rings (lamellae) of matrix. Between the rings of matrix, the bone cells (osteocytes) are located in spaces called lacunae. Small channels (canaliculi) radiate from the lacunae to the osteonic (haversian) canal to provide passageways through the hard matrix. In compact bone, the haversian systems are packed tightly together to form what appears to be a solid mass. The osteonic canals contain blood vessels that are parallel to the long axis of the bone. These blood vessels interconnect, by way of perforating canals, with vessels on the surface of the bone.
- 13. Spongy Bones Spongy (cancellous) bone is lighter and less dense than compact bone. Spongy bone consists of plates (trabeculae) and bars of bone adjacent to small, irregular cavities that contain red bone marrow. The canaliculi connect to the adjacent cavities, instead of a central haversian canal, to receive their blood supply. It may appear that the trabeculae are arranged in a haphazard manner, but they are organized to provide maximum strength similar to braces that are used to support a building. The trabeculae of spongy bone follow the lines of stress and can realign if the direction of stress changes.
- 14. Structure of Compact and Sponge Bones
- 15. BONE DEVELOPMENT AND GROWTH The terms osteogenesis and ossification are often used synonymously to indicate the process of bone formation. Parts of the skeleton form during the first few weeks after conception. By the end of the eighth week after conception, the skeletal pattern is formed in cartilage and connective tissue membranes and ossification begins.
- 16. Bone development continues throughout adulthood. Even after adult stature is attained, bone development continues for repair of fractures and for remodeling to meet changing lifestyles. Osteoblasts, osteocytes and osteoclasts are the three cell types involved in the development, growth and remodeling of bones. Osteoblasts are bone-forming cells, osteocytes are mature bone cells and osteoclasts break down and reabsorb bone.
- 17. Type of Ossification Intramembranous ossification involves the replacement of sheet-like connective tissue membranes with bony tissue. Bones formed in this manner are called intramembranous bones. They include certain flat bones of the skull and some of the irregular bones. The future bones are first formed as connective tissue membranes. Osteoblasts migrate to the membranes and deposit bony matrix around themselves. When the osteoblasts are surrounded by matrix they are called osteocytes.
- 18. Endochondral ossification involves the replacement of hyaline cartilage with bony tissue. Most of the bones of the skeleton are formed in this manner. These bones are called endochondral bones. In this process, the future bones are first formed as hyaline cartilage models. During the third month after conception, the perichondrium that surrounds the hyaline cartilage "models" becomes infiltrated with blood vessels and osteoblasts and changes into a periosteum. The osteoblasts form a collar of compact bone around the diaphysis. At the same time, the cartilage in the center of the diaphysis begins to disintegrate. Osteoblasts penetrate the disintegrating cartilage and replace it with spongy bone. This forms a primary ossification center. Ossification continues from this center toward the ends of the bones. After spongy bone is formed in the diaphysis, osteoclasts break down the newly formed bone to open up the medullary cavity.
- 19. The cartilage in the epiphyses continues to grow so the developing bone increases in length. Later, usually after birth, secondary ossification centers form in the epiphyses. Ossification in the epiphyses is similar to that in the diaphysis except that the spongy bone is retained instead of being broken down to form a medullary cavity. When secondary ossification is complete, the hyaline cartilage is totally replaced by bone except in two areas. A region of hyaline cartilage remains over the surface of the epiphysis as the articular cartilage and another area of cartilage remains between the epiphysis and diaphysis. This is the epiphyseal plate or growth region.
- 20. Bones Growth Bones grow in length at the epiphyseal plate by a process that is similar to endochondral ossification. The cartilage in the region of the epiphyseal plate next to the epiphysis continues to grow by mitosis. The chondrocytes, in the region next to the diaphysis, age and degenerate. Osteoblasts move in and ossify the matrix to form bone. This process continues throughout childhood and the adolescent years until the cartilage growth slows and finally stops. When cartilage growth ceases, usually in the early twenties, the epiphyseal plate completely ossifies so that only a thin epiphyseal line remains and the bones can no longer grow in length. Bone growth is under the influence of growth hormone from the anterior pituitary gland and sex hormones from the ovaries and testes.
- 22. Even though bones stop growing in length in early adulthood, they can continue to increase in thickness or diameter throughout life in response to stress from increased muscle activity or to weight. The increase in diameter is called appositional growth. Osteoblasts in the periosteum form compact bone around the external bone surface. At the same time, osteoclasts in the endosteum break down bone on the internal bone surface, around the medullary cavity. These two processes together increase the diameter of the bone and, at the same time, keep the bone from becoming excessively heavy and bulky.
- 23. DIVISION OF THE SKELETON The adult human skeleton usually consists of 206 named bones. These bones can be grouped in two divisions: axial skeleton and appendicular skeleton. The 80 bones of the axial skeleton form the vertical axis of the body. They include the bones of the head, vertebral column, ribs and breastbone or sternum. The appendicular skeleton consists of 126 bones and includes the free appendages and their attachments to the axial skeleton. The free appendages are the upper and lower extremities, or limbs, and their attachments which are called girdles.
- 24. Axial Skeleton (80 bones) Skull (28) Cranial Bones Parietal (2) Temporal (2) Frontal (1) Occipital (1) Ethmoid (1) Sphenoid (1)
- 25. Facial Bones - Maxilla (2) - Inferior nasal concha (2) - Mandible (1) - Nasal (2) - Platine (2) - Zygomatic (2) - Lacrimal (2) - Vomer (1)
- 26. Auditory Ossicles - Malleus (2) - Incus (2) - Stapes (2)
- 27. Vertebral Column - Cervical vertebrae (7) - Thoracic vertebrae (12) - Lumbar vertebrae (5) - Sacrum (1) - Coccyx (1)
- 28. Thoracic Cage - Sternum (1) - Ribs (24)
- 29. Appendicular Skeleton (126 bones) Pectoral girdles - Clavicle (2) - Scapula (2)
- 30. Upper Extremity - Humerus (2) - Radius (2) - Ulna (2) - Carpals (16) - Metacarpals (10) - Phalanges (28)
- 31. Pelvic Girdle - Coxal, innominate, or hip bones (2)
- 32. Lower Extremity - Femur (2) - Tibia (2) - Fibula (2) - Patella (2) - Tarsals (14) - Metatarsals (10) - Phalanges (28)
- 33. ARTICULATION An articulation, or joint, is where two bones come together. In terms of the amount of movement they allow, there are three types of joints: immovable, slightly movable and freely movable.
- 34. Our joints have two fundamental functions: Give our skeleton mobility Hold the skeleton together, sometimes playing the protective role in the process. For example the rigid joint of the skull, make it secure enclosure for our vital structure Joint are the weakest parts of the skeleton, but their structure resists various forces, such as crushing or tearing, that threaten to force them out of alignment
- 35. CLASSIFICATION OF JOINTS Synarthroses Synarthroses are immovable joints. The singular form is synarthrosis. In these joints, the bones come in very close contact and are separated only by a thin layer of fibrous connective tissue. The sutures in the skull are examples of immovable joints Amphiarthroses Slightly movable joints are called amphiarthroses. The singular form is amphiarthrosis. In this type of joint, the bones are connected by hyaline cartilage or fibrocartilage. The ribs connected to the sternum by costal cartilages are slightly movable joints connected by hyaline cartilage. The symphysis pubis is a slightly movable joint in which there is a fibrocartilage pad between the two bones. The joints between the vertebrae and the intervertebral disks are also of this type.
- 36. Diarthroses Most joints in the adult body are diarthroses, or freely movable joints. The singular form is diarthrosis. In this type of joint, the ends of the opposing bones are covered with hyaline cartilage, the articular cartilage, and they are separated by a space called the joint cavity. The components of the joints are enclosed in a dense fibrous joint capsule. The outer layer of the capsule consists of the ligaments that hold the bones together. The inner layer is the synovial membrane that secretes synovial fluid into the joint cavity for lubrication. Because all of these joints have a synovial membrane, they are sometimes called synovial joints.
- 38. Types of Synovial Joints Hinge Joint In Hinge joint, movement occur in one place only. Examples of hinge joint are at the elbow (humerus and ulna) and knee (femur and tibia) and fingers (between phalanges) Pivot Joint A pivot joint is organized to permit rotation. An example of a pivot joint occurs in the neck where the first two bones of the vertebral column (atlas and axis) come together
- 39. Ball and Socket Joint This joint forms where a ball-like head firs into a cup like cavity. It allow the most freedom of movement. Occur where the head of humerus articulates with the glenoid cavity of the scapula and at the hip where the head of the femur articulates with acetabulum Condyloid Joint Rotation is not possible at this joint, but most other movement occur here. Condyloid joint exists where the radius meets the carpals at the wrist.
- 40. Saddle Joint Rotation is also restricted. The union of the carpals bones with one another and with the metacarpal bones of the thumb occurs at a saddle joint Gliding Joint Permits a gliding movement in a number of different directions between relatively flat, aricular surfaces. The places where the articular processes of the vertebrae come together are examples of gliding joints.
- 41. Movement Allowed by Synovial Joints Flexion 11. Pronation Extension 12. Eversion Hyperextension 13. Inversion Dorsiflexion 14. Protraction Plantar flexion 15. Retraction Adduction 16. Elevation Abduction 17. Depression Circumduction 18. Gliding Rotation Supination