Which system performs better using OFDM to service two different us.pdf
- 1. Which system performs better: using OFDM to service two different users simultaneously with two 20 MHz channels or using OFDMA to service these two users asynchronously using a 40 MHz channel? Can OFDMA achieve better performance than MU-MIMO? Justify your reasoning in terms of the number of simultaneous users supported, multipath mitigation, and the achievable data rate or throughput. Hint: OFDMA may allow all channels of say the 2.4 or 5 GHz bands to be used simultaneously. Solution Multiple input, multiple output-orthogonal frequency division multiplexing (MIMO-OFDM) is the dominant air interface for 4G and 5G broadband wireless communications. It combines multiple input, multiple output (MIMO) technology, which multiplies capacity by transmitting different signals over multiple antennas, and orthogonal frequency-division multiplexing (OFDM), which divides a radio channel into a large number of closely spaced subchannels to provide more reliable communications at high speeds. Research conducted during the mid-1990s showed that while MIMO can be used with other popular air interfaces such as time division multiple access (TDMA) and code division multiple access (CDMA), the combination of MIMO and OFDM is most practical at higher data rates. MIMO-OFDM is the foundation for most advanced wireless local area network (wireless LAN) and mobile broadband network standards because it achieves the greatest spectral efficiency and, therefore, delivers the highest capacity and data throughput. Greg Raleigh invented MIMO in 1996 when he showed that different data streams could be transmitted at the same time on the same frequency by taking advantage of the fact that signals transmitted through space bounce off objects (such as the ground) and take multiple paths to the receiver. That is, by using multiple antennas and precoding the data, different data streams could be sent over different paths. Raleigh suggested and later proved that the processing required by MIMO at higher speeds would be most manageable using OFDM modulation, because OFDM converts a high-speed data channel into a number of parallel, lower-speed channels. OFDMA with 40 MHz will perform better