A three phase grid tied spv system with adaptive dc link voltage for cpi voltage variations

ELECTRICAL PROJECTS USING MATLAB/SIMULINK
Gmail: asokatechnologies@gmail.com, Website: http://www.asokatechnologies.in
0-9347143789/9949240245
For Simulation Results of the project Contact Us
0-9347143789/9949240245
A Three-Phase Grid Tied SPV System with Adaptive dc link voltage
for CPI voltage variations
ABSTRACT:
This paper deals with a three-phase two-stage grid tied SPV (solar photo-voltaic) system. The
first stage is a boost converter, which serves the purpose of MPPT (maximum power point
tracking) and feeding the extracted solar energy to the DC link of the PV inverter, whereas the
second stage is a two-level VSC (voltage source converter) serving as PV inverter which feeds
power from a boost converter into the grid. The proposed system uses an adaptive DC link
voltage which is made adaptive by adjusting reference DC link voltage according to CPI
(common point of interconnection) voltage. The adaptive DC link voltage control helps in the
reduction of switching power losses. A feed forward term for solar contribution is used to
improve the dynamic response. The system is tested considering realistic grid voltage variations
for under voltage and over voltage. The performance improvement is verified experimentally.
The proposed system is advantageous not only in cases of frequent and sustained under voltage
(as in the cases of far radial ends of Indian grid) but also in case of normal voltages at CPI. The
THD (total harmonics distortion) of grid current has been found well under the limit of an IEEE-
519 standard.
KEYWORDS:
1. Adaptive DC link
2. MPPT
3. Overvoltage
4. Solar PV
5. Two-stage

0-9347143789/9949240245
0-9347143789/9949240245
6. Three phase
7. Under voltage
SOFTWARE: MATLAB/SIMULINK
CIRCUIT DIAGRAM:
Fig. 1. System configuration.

0-9347143789/9949240245
0-9347143789/9949240245
CONTROL SYSTEM
Fig. 2. Block diagram for control approach.

0-9347143789/9949240245
0-9347143789/9949240245
EXPECTED SIMULATION RESULTS:
Fig. 3. Simulated performance for, (a) change in solar insolation without feedforward for PV contribution,
(b) change in solar insolation with feed forward for PV contribution,

0-9347143789/9949240245
0-9347143789/9949240245
(c) normal to under voltage (415 V to 350 V),
(d) CPI voltage variation from normal to over voltage (415 V to 480 V).

0-9347143789/9949240245
0-9347143789/9949240245
CONCLUSION:
A two-stage system has been proposed for three-phase grid connected solar PV generation. A
composite InC based MPPT algorithm is used for control of the boost converter. The
performance of proposed system has been demonstrated for wide range of CPI voltage variation.
A simple and novel adaptive DC link voltage control approach has been proposed for control of
grid tied VSC. The DC link voltage is made adaptive with respect to CPI voltage which helps in
reduction of losses in the system. Moreover, a PV array feed forward term is used which helps in
fast dynamic response. An approximate linear model of DC link voltage control loop has been
developed and analyzed considering feed forward compensation. The PV array feed forward
term is so selected that it is to accommodate for change in PV power as well as for CPI voltage
variation. A full voltage and considerable power level prototype has verified the proposed
concept. The concept of adaptive DC link voltage has been proposed for grid tied VSC for PV
application however, the same concept can be extended for all shunt connected grid interfaced
devices such as, STATCOM, D-STATCOM etc. The proposed system yields increased energy
output using the same hardware resources just by virtue of difference in DC link voltage control
structure. The THDs of the grid currents and voltages are found less than 5% (within IEEE-519
standard). The simulation and experimental results have confirmed the feasibility of proposed
control algorithm.

0-9347143789/9949240245
0-9347143789/9949240245
REFERENCES:
[1] M. Pavan and V. Lughi, “Grid parity in the Italian commercial and industrial electricity
market,” in Proc. Int. Conf. Clean Elect. Power (ICCEP’13), 2013, pp. 332–335.
[2] M. Delfanti, V. Olivieri, B. Erkut, and G. A. Turturro, “Reaching PV grid parity: LCOE
analysis for the Italian framework,” in Proc. 22nd Int. Conf. Exhib. Elect. Distrib. (CIRED’13),
2013, pp. 1–4.
[3] H.Wang and D. Zhang, “The stand-alone PV generation system with parallel battery
charger,” in Proc. Int. Conf. Elect. Control Eng. (ICECE’10), 2010, pp. 4450–4453.
[4] M. Kolhe, “Techno-economic optimum sizing of a stand-alone solar photovoltaic system,”
IEEE Trans. Energy Convers., vol. 24, no. 2, pp. 511–519, Jun. 2009.
[5] D. Debnath and K. Chatterjee, “A two stage solar photovoltaic based stand alone scheme
having battery as energy storage element for rural deployment,” IEEE Trans. Ind. Electron., vol.
62, no. 7, pp. 4148–4157, Jul. 2015.

A three phase grid tied spv system with adaptive dc link voltage for cpi voltage variations

More Related Content

What's hot (20)

Viewers also liked (20)

Similar to A three phase grid tied spv system with adaptive dc link voltage for cpi voltage variations (20)

More from Asoka Technologies (20)

Recently uploaded (20)

A three phase grid tied spv system with adaptive dc link voltage for cpi voltage variations