Devry gsp 215 week 7 homework networking commands new
- 1. DEVRY GSP 215 Week 7 Homework Networking Commands NEW Check this A+ tutorial guideline at http://www.assignmentcloud.com/gsp-215-devry/gsp- 215-week-7-homework-networking-commands-new For more classes visit http://www.assignmentcloud.com Week 7 Homework—Networking Commands This week's homework will focus on basic networking commands. Display IP configuration settings. 1. Open a Windows CLI (Start->run type in cmd and press enter) 2. The ipconfig command is used to view a computer's IP address. When your system is resolving the DNS addresses incorrectly, flushing the DNS using ipconfig – flushdns is a helpful command. To release and renew an IP address, use ipconfig – release and ipconfig –renew. What does subnet mask mean? What does default gateway mean?
- 2. 3. Ping is used to verify connectivity to a network. Ping a web address of your choice, and press control + c to stop it. Paste the screenshot below. 4. Run traceroute on a website address of your choice (control + c to stop). Example: tracert devry.edu 5. Nslookup is helpful to know if the DNS is working correctly. Run nslookup against a hostname to see if the name is resolved. Example: nslookupwww.cnn.com 6. The netstat command has many options and gives a lot of information about your network. The –a option will show you the open ports on your computer.
- 3. 7. If you have a Windows machine, go to the control panel on your computer. Then pick network and sharing center. Under view your active networks, you will see a link next to connections (in the above picture it is wired). Click on the link you see next to connections, then click on properties. Select Internet protocol version 4 (TCP/IPv4), and click properties. Note that changing these settings may disconnect you, so click cancel rather than OK. • To obtain IP settings automatically, click obtain an IP address automatically, and then click OK. • To specify an IP address, click use the following IP address, and then in the IP address, subnet mask, and default gateway boxes, type the IP address settings. Take a screenshot of your settings. Why would you choose