An alternative Routing Mechanisms for Mobile Ad-hoc NetworksPresentation2
Download as PPT, PDF1 like570 views
This document outlines a student's research project on proposing an alternative routing mechanism for mobile ad-hoc networks. The student investigated existing routing protocols, proposed a new hybrid protocol, and simulated its performance in NS2 compared to AODV and DSDV. Simulation results showed the hybrid protocol had lower packet drop and loss rates than the other protocols. The hybrid protocol switches between proactive and reactive modes based on power consumption, mobility, and vicinity.
An alternative Routing Mechanisms for Mobile Ad-hoc NetworksPresentation2
- 1. An alternative Routing Mechanisms for Mobile Ad-hoc Networks Awos Khazal Ali Supervisor Dr. Shukor abd. Razak Faculty of Computer Science & Information Systems Universiti Teknologi Malaysia
- 3. Outlines Introduction Problem background Problem Statement Project Objectives Project scopes METHODOLOGY - Operational Framework Results & Discussion Conclusion Future work
- 4. Introduction There are two kinds of mobile wireless networks. The first is known as infrastructure network, with mobile nodes and base station. The base station is responsible for routing, security and all issues in this kind of network.
- 5. The second type of mobile wireless network is the infrastructure-less mobile network, commonly known as the mobile ad-hoc network (MANET). ad-hoc network are collections of mobile nodes, dynamically forming a temporary network without pre- existing network infrastructure or centralized base station. These nodes can be arbitrarily located and are free to move randomly at any given time. Network topology is changing because of node’s moving.
- 6. Ad-hoc networks is self- organizing and self-configuring “multi-hop” network. ad-hoc does not require any fixed infrastructure such as transceiver base stations or even cables. This figure illustrates an example of ad-hoc network with four nodes
- 7. Ad-hoc networks are suited for use in situations where infrastructure is either not available, not trusted, or should not be relied on in times of emergency. few examples for ad-hoc networks: military solders and equipments in the battlefield ("open environment"), sensor networks for various research purposes, emergency rescue after an earthquake or flood, and temporary offices, conference or meeting in such company ("close or limited environment").
- 8. Problem background The concept of routing can be described as the process of path finding. In (MANETs) the main problem in routing mechanism, is how to send a packet from one node to another when there is no direct link exist between source and destination nodes. Routing in ad-hoc networks has always been a challenging task. The major reason for this is because of the characteristics of MANET itself that consists of high degree of node mobility, limited bandwidth, variable capacity links, energy-constrained operation, limited physical security.
- 9. There are several techniques that have been proposed so far and all of them have their own advantages and limitations. Each technique tries to determine the optimal path for packets delivery from source to destination nodes in reliable and fast manner. Some of the proposed routing mechanisms are suitable to be used in various MANET environments (i.e. open, localized, and organized environments), while some others are only suitable to be deployed in a specific environment.
- 10. Problem Statement Routing is one of the most important open issues in MANET research. The problem of routing can be divided into two areas: route discovery and route maintenance. The high mobility, low bandwidth, and limited computing capability characteristics of mobile hosts make the design of routing protocols very challenging. The protocols must be able to keep up with unpredictable changes in network topology with as minimal message exchanges as possible and in the most efficient way.
- 11. This project proposes an alternative solution for ad-hoc network routing mechanism which aims to improve the reliability of the path chosen between source and destination nodes.
- 12. Project Objectives This project had accomplished the following objectives: 1- Investigate existing routing mechanisms in MANET environment. 2- Propose an alternative routing mechanism based upon existing schemes. 3- To analyze the performance of the proposed mechanism compared to the existing schemes.
- 13. Project scopes The scope of this project is as follow. The investigation of existing MANET’s routing mechanisms is focusing upon open environment. The proposed routing mechanism will focus upon the route discovery performance not on the security issues. The analyses of the proposed routing mechanism will be conducted in simulation experiments .
- 14. METHODOLOGY Project Structure - Introduction for ad-hoc networks. - Defining the problem background. - Determining the problem statement. - Scopes of project. This study start by, Data collecting and analysis existing routing protocols. Then, a new routing protocol (Hybrid), for mobile ad-hoc network (MANET) was proposed.
- 15. Simulate the new routing protocol using Network Simulator 2 (NS2) in order to evaluate the performance. Finally, is compared the performance of new routing protocol with previous protocols to see the differences between them. The following figure illustrates the project structure.
- 16. Project Structure Steps Problem Definition Data collection and analysis Simulate the new protocol (NS2) Findings and Result Propose New routing Protocol
- 17. Operational Framework Project Operational Framework
- 18. Initial Study covered mobile ad-hoc network (MANET) sequentially to define the problem statement through deferent altitudes. Reviewed Related Literature, the main related work for routing in mobile ad-hoc network was reviewed from books, journals, and some Internet articles. Reviewing was focused on ad-hoc routing protocols. Propose New Routing Protocol, based on previous protocols had been done.
- 19. Simulation, The new proposed routing protocol was simulated to present the performance of the overall system. The simulation was done using, Network Simulator 2 (NS2) tools. Comparison, Results of this project are measured by comparing the performance of new ad-hoc routing protocol that proposed in this study, and previous routing protocols; to see the differences between these protocols. The following flowchart illustrates the research methodology steps for this study.
- 21. Results & Discussion Simulation was done by using network simulator 2 (NS2), v 2.30. the following Table illustrates the simulation setup. Simulation parameter Value Channel type Wireless Channel MAC type 802.11 Link layer type Traditional Link Layer (LL) Antenna model Omni-directional (unity gain) No. of nodes 50 No. of sending nodes 1 No. of receive nodes 1 Simulation time 300 Sec Size of simulation area 800m x 800m Initial Power level 104000 watt Power consumption /packet 228.0 joules
- 22. AODV, DSDV, and Hybrid (proposed protocol) were implemented under same scenario. 50 wireless nodes. The nodes are placed randomly within an 800m x 800m simulation area. The mobility model used was the random waypoint model. The simulation time is set to 300s. The initial battery energy = 104000 watt. Power consumption 228 joules for each send/receive/forward packet from node to node.
- 23. Drop rate: The ratio of lost TCP DATA packets over sent TCP DATA packets. Lost rate: Packet loss is the failure of one or more transmitted packets to arrive at their destination. Packets generation. End –to-end delay: the average delay time of all successfully delivered packets from source node to destination. Metrics
- 24. Results AODV: No. of dropped packets = 117 packets.
- 25. No. of packets generations = 26875 packets. No. of lost packets = 30 packets. AODV:
- 26. No. of dropped packets = 149 packets. DSDV:
- 27. DSDV: No. of packets generations = 20598 packets. No. of lost packets = 37 packets.
- 28. Hybrid: No. of dropped packets = 102 packets.
- 29. No. of packets generations = 28507 packets. No. of lost packets = 24 packets. Hybrid:
- 30. End-to End Delay: DSDV has the lowest ratio in average of delay of delivering packets to destination node. While AODV shows the higher delay during simulation because; when mobility is high, more packets may travel over non- optimal routes with larger hop counts. Hybrid approach gives better performance in terms of end-to-end delay than AODV (reactive).
- 31. AODV vs. DSDV DSDV perform badly at high mobility pattern, because DSDV cannot maintain its routing table update process with high topology changes. In terms end-to-end delay, DSDV have very low delay compare with AODV AODV suffer from long delay, which effect badly on routing performance. AODV manages the packets generation rate better than DSDV. The number of packets generating by AODV is 26875 packets, when DSDV generate 20598 packets only.
- 32. the rate of loss packets by DSDV is greater than loss rate by AODV. The number of loss packets in DSDV is 37 packets, when number of loss packets by AODV is 30 packets. AODV has a better drop packet ratio compare with DSDV. The number of packets that dropped during simulation time by using AODV is 117 packets; while the number of packet that dropped using DSDV is 149 packets. AODV vs. DSDV
- 33. Hybrid vs. AODV in terms of drop packet rate. The number of dropped packets by AODV is 117 packets, while in hybrid approach its 102 packets only. The number of packets that were generated by AODV is 26875, while in hybrid, the number of packets generation was 28507 packets. In terms of packet loss hybrid approach has a better rate compare with AODV. The number of lost packets in hybrid is 24 packets and in AODV is 30 packets. the average of end-to-end delay in AODV is much higher than hybrid
- 34. Hybrid vs. DSDV the hybrids approach perform well in high mobility model unlike DSDV. the number of dropped packets by DSDV during simulation is 149 packets, when in hybrid it just 102 packets. the number of generating packets, it can be easily seen that hybrid approach perform better than DSDV. The number of generating packets by hybrid is 28507 packets, while DSDV generate 20598 packets only.
- 35. DSDV loss 37 packets during simulation, on the other hand hybrid approach shows a good performance with loss packets rate, hybrid just loss 24 packets. The average end-to-end delay, DSDV shows a good delay ratio compare with hybrid approach. Hybrid vs. DSDV
- 36. Hybrid Performance Hybrid protocol contains two sub protocols, one of them act proactively (DSDV) and the other one act reactively (AODV). The switching mechanism between hybrid protocol components should fulfill under specific criteria. based on these criteria, the hybrid routing protocol decide when to act proactively or reactively.
- 37. Hybrid Performance The criteria are as follow: Power Consumption Mobility Vicinity
- 38. The following algorithms illustrate the switching mechanism in proposing hybrid technique basic on the previous criteria. if Power = high and Vicinity = high then If the node is not in "DSDV", it switches to "DSDV". else if Power = high and mobility = low then If the node is not in "DSDV", it switches to "DSDV". else if Vicinity = high and Mobility = low then If the node is not in "DSDV", it switches to "DSDV" Otherwise, switch to AODV.
- 39. Conclusion: Proposing a new hybrid routing technique for mobile ad hoc networks. this new hybridization routing strategy is combined between proactive (DSDV) and reactive (AODV) techniques. this new hybrid technique has its own switching mechanism to switch between AODV and DSDV. this switching process fulfill under specific criteria. base on these criteria, the hybrid routing protocol decide when act proactively (utilize DSDV) or reactively (utilize AODV).
- 40. Conclusion: These criteria as follow: Power Consumption Mobility Vicinity This proposed hybrid technique is performing well in large scale networks and high mobility models.
- 41. Future work Implementing real world scenario to see the results of having the proposed hybrid mechanism. Hopefully the concept of this study can be a motivation for further investigation in ad hoc networks routing field with considering more switching criteria like connectivity, and so on. Hopefully this study gives at list an idea and spreading the knowledge in the ad hoc routing field.