Encryptor Install2
- 1. Installation of the Code Encryptor Wireless receiver module. Connections to timer or display. Tally Count up or Code Encryptor Encryptor Plus Encryptor Plus Count Count down Timer 1 - Yellow 1 - Data Out wireless receiver 2 - Green 2 - Data In X X X X 3 - Grey 3 - Ch3 Output (-) Reset Reset Antenna 4 - Red/White 4 - Ch2 N/O Previous Stop 5 - White 5 - Ch2 Common Ground Ground 6 - Brown 6 - Ch1 Common Ground Ground 7 - Brown/White 7 - Ch1 N/O 7 - Next 7 - Start 8 - Brown/Black 8 - Ch1 N/C X X 9 - Red 9 - +12VDC + Power + Power 10 - Black 10 - Ground (-) Ground Ground Tallye Counter Button 1 = Next Button 2 = Previous Burron 3 = Reset Count Up or Count down Timer Button 1 = Start Button 2 = Stop Burron 3 = Reset Federal Communications Commission (FCC) Statement This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information. This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio and television reception. It has been type tested and been found to comply with the limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ? an indoor antenna, have a quality outdoor antenna installed. I f using ? Reorient the receiving antenna until interference is reduced or eliminated. ? the receiver away from the control/communicator. Move ? the antenna leads away from any wire runs to the control/communicator. Move ? the control/communicator into a different outlet so that it and the receiver are on different branch circuits. Plug If necessary the user should consult the dealer or an experienced radio/television technician for additional suggestions. Alzatex, Inc. Www.alzatex.com encryptor_install2.pdf