I.C. ENGINE INTERNAL PARTS WITH WORKING & MANUFACTURING PROCESS WITH MATERIAL
- 1. L. J. POLYTECHNIC, AHMEDABAD SUBMITTED BY: VAIBHAV BHARAMBE Mechanical Engineering Department Thermal Engineering-II PARTS OF I.C.ENGINE
- 2. Piston Cylinder Crankshaft Connecting Rod Camshaft Flywheel Governor Carburetor Inlet & Exhaust valve Piston Rings PARTS OF I.C.ENGINE
- 3. Working It transmits the energy to crankshaft through connecting rod Material Aluminum Alloy 4652 Mfg. Method Casting PISTON
- 4. CYLINDER Working It is a container fitted with piston, where the fuel is burnt and power is produced Material Cast Iron ,30C8 (Low Carbon Steel) Mfg. Method Casting, Forging and after that heat transfer , Machining
- 5. CONNECTING ROD Working It transmits the reciprocating motion of piston to rotary crank Material Low Carbon steel 30C8 Mfg. Method Forging and after that heat heat treatment
- 6. CAM SHAFT Working The cam shaft and its associated parts control the opening and closing of the valves Material Grade 17 cast iron with 1% chrome Mfg. Method Casting, heat transfer, Machining
- 7. CRANK SHAFT Working The working of crank shaft is to transform reciprocating motion in to a rotary motion Material 37C15 Alloy Steel Mfg. Method Casting
- 8. FLYWHEEL Working The working of crank shaft is to transform reciprocating motion in to a rotary motion Material 37C15 Alloy Steel Mfg. Method Casting
- 9. GOVERNOR Working The working of a governor is to control the fluctuations of engine speed due to changes of load
- 10. CARBURETOR Working The function of a carburetor is to atomize and meter the liquid fuel and mix it with the air as it enters the induction system of the engine
- 11. INLET & EXHAUST VALVES Working To open path for inlet fluid or air , To open path for exhaust gases Material Alloy Steel. Mfg. Method Casting than machining
- 12. PISTON RINGS Working To provide good seating fit between the piston and cylinder when piston reciprocate in cylinder Material Cast Iron Mfg. Method Casting than machining