Procedures loga
Download as DOCX, PDF0 likes177 views
The document outlines the steps to create a drawing circuit, including: 1) observing the circuit diagram to understand it, 2) determining and checking the necessary apparatus, 3) testing wires using a power supply, 4) selecting and arranging apparatus in good condition, 5) inspecting air flow tubes, and 6) using a double acting cylinder, double sided solenoid, and distributor. It then describes the six parts of the circuit, which includes two switch limitations, two relay coils, a cylinder, and two switches.
1 of 1
Download to read offline
More Related Content
Ad
Viewers also liked (11)
Ad
Similar to Procedures loga (20)
Procedures loga
- 1. PROCEDURES 1. Observethe drawing circuit and understand it. 2. Determine the apparatus that need to do to create the circuit. 3. Check the wires by using power supply. 4. Chooseand arrangethe apparatus that are in good condition. 5. Check the air flow tube whether it’s in good condition or not. 6. Make surewe use the double acting cylinder, double sided solenoid and distributor. 7. The circuit contains six parts, using two switch limitation, two relay coil, one cylinder two switches which is 3rd switch and zero switch. 8. Direct main supply to 3rd switch, it goes to switch limitation B1 then it is connected to relay coil one and then main supply again. 9. Second part of circuit is the combination of 1st and 3rd . 10.Third connect starts with zero switch and its connect to switch limitation B1. 11.Forth part starts with relay coil K1 then straightto solenoid Y1 then to main supply. 12.Sixth starts with coil K2 then connect with solenoid Y2 then to main supply again.