Safety Procedures while working in height
- 1. SAFETY ASSIGNMENT Roman Man Shrestha st120294 Shwe Yee Oo st120321 Kaung Wunna Kyaw st120332 Y.D. Gopal Rayadu st120357 Thae Nu San st120432
- 2. HOW TO LIFT WORKER? USING PASSENGER LIFT 1. Installation of PASSENGER LIFT The employer shall comply with the manuf acturer's specifications and limitations app licable to the operation of all hoists and el evators. Metal Studs or stand must be settled with concrete at 90° Towers shall be anchored to the structure at intervals not exceeding 25 feet. Hoist way doors or gates shall be not less than 6 feet 6 inches high and shall be prov ided with mechanical locks which cannot b e operated from the landing side, and shal l be accessible only to persons on the car.
- 3. USING PASSENGER LIFT CONTINUE 2 OPERATION All material hoists shall conform to the requirement s of ANSI A10.5-1969, Safety Requirements for Ma terial Hoists. Rated load capacities, recommended operating sp eeds, and special hazard warnings or instructions s hall be posted on cars and platforms. No person shall be allowed to ride on material hoist s except for the purposes of inspection and mainte nance. Hoisting ropes shall be installed in accordance with the wire rope manufacturers' recommendations. Hoist repair works must be done by those who are competent/qualified and the repairing work shall co mply with the manufacturer's instructions.
- 4. HOW TO BRING MATERIAL? USING MATERIAL HOIST • Train workers on the proper procedures for erecting, inspecting, testing and mai ntaining the material hoist as recomme nded by the manufacturer. • Check for not exceeding the safe load li mit (<1000kg) of the hoist while carryin g clay tile. • Inspect hooks, ropes, bricks for avoidin g damages and wire ropes and chains l ubricated. • Use of PPE who will operate the Engin e IN Ground site • Use of Sign Board ad lifting speed must be fixed to 25meter/min
- 5. • According to personal fall arrest syste m(PFAS) - Full body harness (ANSI stan dard) - Retractable lanyard - Standard nylon harness (weldi ng at height) - Safety net - Safety belt • Maintain a Daily and weekly site supe rvision Report • Provide rails and non-slippery carpet if site consist of slippery condition. HOW TO WORK SAFELY?
- 6. HOW TO KEEP MATERIAL AT HEIGHT? Step1: Implement a fall protection for tools program and specification Step2: All overhead equipment and locations for loo se items are inspected and recorded Step3: Falling objects are controlled and slippery s urfaces be avoided Step4: Equipment's such as toe boards of standar d size 4inches with clearance , guardrails and platfo rms must be checked by safety supervisor Step5: After installation of toe boards, guardrails an d platforms, be ensure with safety standard by safe ty supervisor Step6: workplaces at height have to clear of loose materials and store materials well back from edges Step7: Proper warning sign boards have to install n ear the edges
- 7. HOW TO PROTECT WORKER WORKING BELOW? • Firstly all the employees should be trained on how to use tools and safety practices to be considered at work place. • Before performing the work hazards should be car efully assessed to the worker by the authority. • Dispose all wastes, and unwanted materials must be disposed of at a designated place. • Do not leave planks with nails on passageways. • Use toe boards, screens on guardrails or scaffold s to prevent falling objects. Toe boards should be capable of withstanding of objects which were he avy in any downward and outward direction. • Use debris nets, catch platforms or canopies to ca tch or deflect falling objects. By using debris nets i f any worker slips from height it would somewhat slow the force of falling objects.