IRJET- Detection and Classification of Leaf Diseases

International Research Journal of Engineering and Technology (IRJET) e-ISSN: 2395-0056
Volume: 06 Issue: 03 | Mar 2019 www.irjet.net p-ISSN: 2395-0072
© 2019, IRJET | Impact Factor value: 7.211 | ISO 9001:2008 Certified Journal | Page 4732
Detection and Classification of leaf diseases
Debleena Mondal1, Shivani Pancholi2, Sachin Jain3
1,2 B. Tech, Department of Computer Science & Engineering
Parul University, Waghodia Road, Limda, Vadodara, India
3Assistant Professor, Department of Computer Science & Engineering
Parul University, Waghodia Road, Limda, Vadodara, India
------------------------------------------------------------------------------------------------------------------------------------------------
Abstract- Our country India has always been an
agriculture dominant country from the beginning of its
civilization. Agriculture not only provides food, fodder and
fuel for people but also is a way to earn livelihood for most
of the people living in rural areas. So, all the people living
either in rural or in urban areas directly or indirectly
depends on the agricultural yield. The population of our
country has increased drastically after the independence
which puts a lot of pressure on the agricultural sector to
support it. In such a scenario if the crops get infected by
disease, it can have adverse effects on the people as well as
economy of the country. Unlike the old times new
technologies are developed and used today to detect these
diseases in plants because the manual process of detection
took a lot of time, effort and cost. Using the modern
techniques diseases can be detected well in time and can
be prevented from spreading. Many methods have been
developed till date to execute the process of detection and
classification such as k-Nearest Neighbor Classifier,
Support Vector Machine, Principal Component Analysis,
Linear discriminant analysis, Artificial neural network,
Fuzzy logic etc.
KEYWORDS: Image processing, k-Nearest Neighbor,
SVM, GLCM, Neural network
1. INTRODUCTION
The basic requirement of all the living organism to
sustain their life is air, water and food. For the humans
and other animals, we directly or indirectly depend on
the plants for food. Plants also provides oxygen to the
animals which we breathe in during the process of
respiration which circulates in our blood and provide
energy. Therefore, all the humans and animals depend
on plants for their survival. Agriculture is not just a way
to support life on earth, it also provides fuel, fodder and
employment to lots of people who earn their livelihood
from farming only. Thus, agriculture contributes a great
deal in the economy of the country. In such a scenario it
is very important that the plants must be kept healthy.
But it is not easy to do so. Because plants can also suffer
from disease in a very similar way that animals do. Like
animals, plants can be infected by microorganisms like
fungi, bacteria, viruses, viroid, protozoa etc. The other
cause for diseases in plants can be excess or lack of
mineral uptake by plants from the soil. Some of the
diseases are Anthracnose, Bacterial blight, Apple scab.
Crecospora leaf disease, Bacterial Canker, Black knot,
Blossom end rot, Cedar apple rust etc. They can cause
havoc for the farmers and for the economy. So, these
diseases in plants must be detected well in time and
must be classified so that proper measures could be
taken to either prevent or recover from the disease. In
early times, when people were unaware about the
advances in science and technology the work of
detection was done manually which took a lot of effort,
time and capital. But with the advanced technology being
developed over time it is much easier to detect the
diseases well in time and saves a lot of time and effort of
the farmers. In this paper the advanced method of image
processing has been used to detect and classify the
diseases. The solution to the problem given in this paper
comprises of four main phases; the first phase includes
the process of creation of a color transformation
structure on the RGB leaf image and then, the application
of color space transformation for the transformation
structure. Then image thus obtained is segmented using
the clustering technique of K-means. The second phase
comprises of steps that include removal of unnecessary
part (green area) within leaf area that is to be
dragonized. In third phase calculation of the texture
features for the segmented infected images of the object.
In the fourth and the last phase the extracted features
from previous phase are passed through a pre-trained
neural network.
2.PROPOSED METHODOLOGY
For the image processing techniques to be carried out
first of all the process of image acquisition of various
leaves should be done using high resolution camera so
that we can achieve better results & efficiency. Then the
image processing techniques are applied to these images
to extract useful features that are necessary for further
analysis. The sequential steps being followed in order to
do so are:

Figure 1. Block Diagram of proposed approach
2.1 IMAGE PREPROCESSING
When we acquire a digitized image, noise gets added to it
which disturbs the image by adding some unwanted
signals to it which can result in inadequate results and so
it should be removed. For removing these noises
different filtering techniques are used. Color space
transformation structure is created for the acquired
image. For achieving greater precision for the process of
detection and classification, creation of a device
independent color space is necessary. In a device
independent color space, the properties of an image like
brightness or contrast doesn’t depend on the device on
which image is to be taken. This conversion is useful
because the actual properties of an image is kept in its
original state.
2.2 IMAGE SEGMENTATION
The image obtained after the above phase is taken for
segmentation. In segmentation process different number
of segments are created based on the similarities in the
properties of different pixels. For the accurate detection
of disease, the green cells of the leaves must be masked.
The green cells of a leaf indicate that they are healthy
cells and thus don’t contribute much in the identification
of diseases. Here the method of K-mean clustering is
used for dividing the cells into different cluster. There
are K number of clusters each containing their own
centers. First these centers are placed at any random
position but are placed in a way that all these k centers
remain as far as possible from each other. Then each
datapoint is taken and assigned a cluster depending on
their closeness with a given center After this the mean of
all the data points in a cluster is calculated and the new
center is found out. These two steps are repeated until
no more changes can be done to these clusters.
2.3 FEATURE EXTRACTION
The segment of interest i.e., the segment containing the
disease is taken and looked for different features such as
energy, entropy, mean, standard deviation homogeneity,
skewness etc. These features can be calculated by finding
the HIS components of the image. The H(hue)
component describes the color itself but in the form of
an angle. The S(saturation) component describes that
how much are the colors mixed with white color. The
I(intensity) component of the color describes its mixing
with black color. 0 means black and 1 means white.
After this GLCM (Gray level cooccurrence matrix) is
generated for every H and S image of the infected cluster.
A function is used to calculate this GLCM matrix.
2.4 CLASSIFICATION
After the extraction of all the features these features are
given to a classifier to classify the type of disease with
which the plant is infected. For the process of
classification, a multiclass SVM (Support vector
machine) classifier has been used. An SVM is a binary
classifier which can classify the given dataset into two
separate classes. These classes are defined based on a
hyperplane. The main objective is to determine a
function which can determine the hyperplane. The
hyperplane must be such that it maximizes the distance
between the support vectors. Support vectors are the
data objects that lie on the border on either side of
hyperplane.
Figure 2. A Linear SVM
A multi-class SVM converts the data set to quite a few
binary problems, It uses one against all approach to
determine the class of disease. In this approach, there
will be one binary SVM for each of the class to isolate the
dataset of one class from that of the other classes.
Image Preprocessing
Image Segmentation
Feature extraction
Classification
Diagnosis results

2.5 DIAGNOSIS RESULTS
This stage shows the result of detection and
classification process. It tells the name of the disease
with which a plant is infected. It also shows how much of
the area of the given cluster of cells is infected with the
disease. The percentage of area being affected being
affected can simply be calculated using a simple formula:
Total % affected area = (No. of affected leaf pixels /Total
no. of leaf pixels) ∗ 100
3. CONCLUSION
In our fast running livelihood where agriculture plays a
major role in our livelihood by providing us with basic
needs of food and fodder, it is our responsibility to keep
them protected from different types of diseases which
can be caused by different kind of pathogens, pests etc.
An early detection and prevention method should be
applied for which different image processing techniques
are developed. All the techniques work towards the
same goal of achieving high accuracy in detecting these
diseases. So, this paper represents various approaches
that have been adopted by researchers for detection and
recognition of various plant leaf diseases. Among all the
different techniques used for the experiment the best
technique will be carried out which gives maximum
profit. Where a technique has benefits it also comes with
several limitation. There is still no general method or a
common system that can be used to apply on different
datasets. So a method is needed that can be commonly
applied to all kinds of data.
REFERENCES
[1] Prakash M.Manikar, Shreekant Ghorpade, Mayur
Adawadkar “Plant leaf disease detection and
classification using image processing technique”
IJIERE Volume 2, Issue 4,2015.
[2] Rakesh Chaware, Rohit Karpe, Prithvi Pakhale, Prof.
smita desai “Detection and recognition of leaf
disease using image processing ” IJESC Volume
7,Issue 5, 2017
[3] Vijay Borate, Sheetal Patange, Vaibhav vede, Onkar
kale “Plant leaf disease detection using machine
learning” IJARIIE Volume 4, Issue 2,2018
[4] M.Akila, P.Deepan “A review of different
classification technique in machine learning using
weka for plant disease detection ” IJERT Volume
6,Issue 7,2018
[5] R.Ramya, Dr.P.Kumar, D.Mugilan, M.Babykala
“detection and classification of plant leaf disease by
using deep learning algorithm” IRJET Volume 5,
Issue 5,May 2018
[6] Pooja kulinavar,Vidya I. Hadimani "Classification of
leaf diseases based on multiclass SVM classifier"
IJARIIT Volume3, issue 4, 2017
[7] P.R.Patil, Prof. N.B.Bhawarkar “Crop disease
detection with preventive measures using image
processing” IJERA, ISSN:2248-9622
[8] Aarju Dixit, Sumit Nema “Wheat leaf disease
detection using machine learning method” IJCSMC
Volume 7, Issue 5 May 2018
[9] Rani Pagariya, Mahip Bartere “Review paper on
identification of plant disease using image
processing technique” IJARCET, Volume 3, Issue
11, November 2014.
[10] H.al-Hiary, S.Bani ahmad, M Reyalat,
M.Barik, Z.AL Rahamneh “Fast and accurate
detection and classification of plant diseases”
IJCA Volume 17,Issue1, March 2011
[11] Priti Badar, Suchitra C. “Disease detection of
pomegranate plant using image processing”
IJCSMC, Volume 5, Issue 5, May 2016.
[12] www.mathsworks.in
[13] Priti Badar, Suchitra C. “Disease detection of
pomegranate plant using image processing”
IJCSMC, Volume 5, Issue 5, May 2016.

IRJET- Detection and Classification of Leaf Diseases

More Related Content

What's hot (20)

Similar to IRJET- Detection and Classification of Leaf Diseases (20)

More from IRJET Journal (20)

Recently uploaded (20)

IRJET- Detection and Classification of Leaf Diseases