Aeronautical ad hoc networks revised
- 2. Group members ❖ Huda,Fariha Rowshan 16-31209-1 ❖ Yeasin, Arafat 15-30902-3 ❖ Ovi,Tanjil Ahmed 15-30821-3
- 3. INTRODUCTION “Ad Hoc Networking is a novel approach in increasing the data rate and practicality of future in-flight broadband Internet access.” Reduces: --the Internet traffic load on satellite nodes --propagation delay. -Algorithms used: -A dynamic routing algorithm and a new cost metric for increasing path duration is introduced to assist.
- 4. INTRODUCTION(CONTINUED) •The wide spread use of on-board broadband Internet access particularly in the case of aeronautical systems is gradually taking off. •Bypass the long propagation delay of the satellite link for delay sensitive Internet applications. • The proposed model is to provide direct communications, also among planes. • Methods of wireless data communication as shown in Fig. 1.
- 5. INTRODUCTION(CONTINUED) • three-layered topology. • Middle layer: airplanes directly communicate with each other. •The primary application of ad-hoc networks has been for small to medium scale devices that are usually restricted by power, bandwidth, and range. •It is possible to extend a MANET to almost a global network level. Green: Gateway Red: Aircraft Blue: Satelite
- 6. •Able to share their on-board cached data and Internet access. •Have different mobility properties and characteristics such as speed, direction, randomness, and consistency of motion. •Commercial passengers on aircraft over a continent may be accessing the same data such as news, information about accommodation, travel and other tourist related information. •data need to be updated regularly via the Internet. •Do not occupy enormous amount of disk space on an on-board system. ADVANTAGES AND DISADVANTAGES
- 7. AD HOC ROUTING AMONG PLANES A. Aeronautical Mobility and Routing Model A. Aeronautical Routing and Definition of “Best” Path . A. Doppler Shift of Packets . A. Multipath Doppler Routing Algorithm .
- 8. Aeronautical Mobility and Routing Model ❑ The aeronautical system has certain inherent mobility characteristics that qualify it to have its own unique mobility model. ❑ Group mobility in aeronautical systems: ❑ when planes commute to and from common regions.
- 9. Cont…….. ❑ Moving above or below each other: since airplanes are not all at the same altitude, (altitude is based on environmental pressure rather than actual distances above sea level) forming a 3-D layer of mobile nodes.
- 10. Aeronautical Routing and Definition of “Best” Path ❑ Individual links on a path must be maintained for successful communication. In the proposed aeronautical routing protocol the primary aim is to successfully receive some data d from any node that can provide the data. ❑ Velocity Link Cost (VLC) equation: VLC = -v (if v is negative. i.e. approaching) = 2v (if v is positive. i.e. receding)
- 11. Cont… ❑ A best path scenario: -As mentioned earlier, individual links on a path must be maintained for successful communication.
- 12. Doppler Shift of Packets ❑ A property that is a direct consequence of the aircraft’s high speed, which affects radio communication, is the Doppler shift that causes apparent change to the frequencies of radio signals transmitted to and from planes. ❑ Equation of Doppler value: Doppler Value = -c (f / f0 -1) … (if f / f0 < 1) … approaching Doppler Value = +2c (f / f0 -1) … (if f / f0 < 1) … receding
- 13. Multipath Doppler Routing Algorithm ❑ The proposed on-demand routing protocol Multipath Doppler Routing (MUDOR), takes into account mobility as a parameter in its routing procedure. ❑ There are several Doppler values used in MUDOR. 1. The Doppler (shift) Value experienced by the packet as it travels from the previous node to the current node. It is called PDV. 2. The Packet Header Doppler Value (PHDV) is the bottleneck Doppler Value in the packet header. The PHDV is updated at each node (both on the RREQ and RREP) by being replaced by the larger of the two values of PDV and PHDV. 3. (BDVSF) termed Best Doppler Value So Far (BDVSF). This is used as a discriminator for identical request packets.
- 14. SIMULATION OF ROUTING PROTOCOL A. Simulation for Single-hop in Relation to Node Density: There are two routing schemes: • Choose closest node for routing • Repeat when associated node leaves LOS Scheme 2 is performed as follows: • Out of nodes within range, select the node with closest relative velocity • Repeat when associated node leaves LOS
- 15. SIMULATION OF ROUTING PROTOCOL
- 16. SIMULATION OF ROUTING PROTOCOL
- 17. SIMULATION OF ROUTING PROTOCOL B. Simulation for Multihop With Regard to Communication Range for a Real World Scenario:
- 18. SIMULATION OF ROUTING PROTOCOL
- 19. Conclusion Doppler Shift of packet Voronoi-clustering Quality of service