IRJET- Cascaded Multilevel Inverter with MPPT for Grid Connected PV System

International Research Journal of Engineering and Technology (IRJET) e-ISSN: 2395-0056
Volume: 06 Issue: 04 | Apr 2019 www.irjet.net p-ISSN: 2395-0072
© 2019, IRJET | Impact Factor value: 7.211 | ISO 9001:2008 Certified Journal | Page 4651
Cascaded Multilevel Inverter with MPPT for Grid connected
PV System
Dinesh Kumar1, Dinesh Menaria2, Farhat Khanam3, Gaurav Jain4, Mrs. Monika Vardia5
1,2,3,4,5EE DEPARTMENT GITS,UDAIPUR
--------------------------------------------------------------------------***-------------------------------------------------------------------------
Abstract-This paper presents a cascaded multilevel
inverter with MPPT for grid connected application.
Interconnection of solar and grid is a most demanding
topic now a days. The main purpose of this paper is to
design a multilevel inverter based on artificial intelligence
technology and develop the Simulink model of cascaded
multilevel inverter for grid connected pv system. Used
individual MPPT technique for each solar panel to extract
maximum power from solar panel and it is improve the
overall efficiency of system. The simulation model has
been developed by using MATLAB/Simulink.
Keywords- photovoltaic (PV), maximum power
pointtracking(MPPT), cascaded multilevel inverter.
I. INTRODUCTION
Renewable energy sources have become a major
necessity of today's era because conventional energy
sources are highly exhaustible and will deplete very soon
in the nearest future. Photovoltaic is one of the important
renewable energy sources compared to other renewal
energy sources. Solar energy is considered a very
promising source for electric power generation. Two
technologies which are widely used today to provide
power are either standalone loads or for connection to the
power system grid. A standalone solar photovoltaic
system cannot provide a continuous supply of energy due
to seasonal and periodic variations. Therefore, in order to
meet the load demand, grid connected energy systems are
now being implemented.Distributed power generation
systems are widely recognized as an unpreventable trend
in today’s power utilities. Among them, the use of
photovoltaic (PV) solar energy for grid connected
application is fast growing market. Since the PV
technology has some insuperable features, such are
noiseless, fuel- and pollution- free generation, lack of
wearing parts and high reliability; it has potentialto
become a main renewable energy source of the future.For
maximum utilization distributed power systems are the
most suitable in photovoltaic power systems. Cascaded H-
Bridge type multilevel inverters are the appropriate one
for the distributed photovoltaic power system. Fuzzy logic
based intelligent controller is used in continuous
monitoring of the grid connected photovoltaic power
system and controlling the cascaded H-bridge inverter.
II. SYSTEM DESCRITION
A. About block diagram
Figure 1 Block Diagram of grid connected PV power system
The cascaded inverter topologies are chosen for grid-
connected PV systems to reduce the cost and improve the
efficiency.
In cascaded inverter topologies several converters
are connected in series to reach the high voltage/power
level. This will reduce voltage stresses on the
semiconductor switches in each converter. Therefore, low
voltage rating MOSFETs, which cost less, can be even
applied to large-scale PV systems to reduce the cost of PV
inverters. Also, the cascaded PV inverter can reach a high
power level without having to sacrifice the utilization of
PV modules, leading to a high overall efficiency of PV
systems. In addition, compared to other converter
topologies, the cascaded topology itself has higher
efficiency due to the low switching frequency. By applying
the cascaded topology, the target of high efficiency will be
achieved as well. Thus, the cascaded H-bridge multilevel
inverter is applied to single-phasegrid-connected PV
systems. The control scheme with individual MPPT
control will be developed to improve the overall
efficiency of the system. But the solar powered multi-level
inverter introduces a lot of harmonics. Therefore fuzzy
logic based intelligent controller has been implemented
for voltage regulation at Point of Common Coupling of
Grid connected PV Power System.

B. Modelling of a solar cell
The simplest equivalent circuit of a solar cell is a
current source in parallel with a diode. The output of the
current source is directly proportional to the light falling
on the cell (photocurrent Iph). During darkness, the solar
cell is not an active device; it works as a diode, i.e. a p-n
junction. It produces neither a current nor a voltage.
However, if it is connected to an external supply (large
voltage) it generates a current ID, called diode (D) current
or dark current. The diode determines the I-V
characteristics of the cell.
Figure 2 The equivalent PV cell circuit
C. Cascaded H- bridge Inverter
The multilevel inverter using with separate DC source
may be obtain from batteries, fuel cell and solar cell.
Nowadays this topology becomes very popular in high
power supply and adjustable speed drive application.
When two or more H- bridge connecting in series their
output voltage can be combine to from different output
levels, increasesing total output voltage and its rated
power also increases. In general term when n number of
H- bridge connected in series 2n+1 different voltage level
is obtained.
Figure 3 single phase structure of a multilevel cascaded H- bridge
inverter.
III. PV CELL CHERACTERISTICS
Nonlinear Characterstic Of Pv’s
Photovoltaics have nonlinear characteristics, where
the performance and output power are directly affected
with the change of the operating conditions like
temperature and solar irradiance. Figures 4, 5, 6 and 7
shows the effect of change in temperature and solar
irradiance on PV’s output current, voltage and power.
Figure 4 Effect of temperature changes on I-V curves
Figure 5 Effect of temperature changes on P-V curves.
Figure 6 Effect of solar irradiance changes on I-V curves
Figure 7 Effect of solar irradiance changes on P-V curves
IV. PROPOSED MODEL
Figure 8 Photovoltaic Input to cascaded Multilevel Inverter
V. SIMULATION RESULTS
The simulation is performed in Matlab Simulink.
A. Effect of different irradiance
The characteristics of the SunPower-SPR305 and
Kyocera 205GX-LP array are shown in Fig. 9 to 12 below.

Fig.9: I-V and P-V characteristics of one module at 25°C and at different
irradiance
Fig.10: I-V and P-V characteristics of string at 25°C and at different
irradiance
Fig.11: I-V and P-V characteristics of one module at 25°C and at different
irradiance
Figure12 I-V and P-V characteristics of string at 25°C and at different
irradiance
B. Effect of Change of Temperature
Fig.13: Power v/s Voltage characteristic of PV system at standard
irradiance and at different temperature
Fig.14: Current v/s Voltage characteristic of PV system at standard
irradiance and at different temperature
C. Effect of change of Irradiance
© 2019, IRJET | Impact Factor value: 7.211 | ISO 9001:2008 Certified Journal | Page4653

Fig.15: current v/s voltage characteristic of cell at standard temperature
and at different irradiance
Fig.16: Power v/s voltage characteristic of cell at standard temperature
and at different irradiance
D. Simulation of PV system without MPPT control
Simulations were performed on the proposed PV
system when MPPT is disabled to illustrate the effect of
duty cycle of boost converter on performance parameters
of the proposed system. The simulation presents an
analysis of the photovoltaic array 200.8 kW with the boost
converter to track the maximum power point.
Figure.17: Plot of output voltage, power and duty cycle. (D=0.25)
Figure.18: Output load voltage and load current of PV system
E. Response of the Proposed PV Model with “Perturb and
Observe” MPPT Technique
(a) Under Constant Irradiance
In this case, Irradiance is kept constant at 1000
W/m2 and P &O MPPT technique is applied to control the
duty cycle of the dc- dc boost converter so as to track the
maximum power.
Time(t) sec
Figure 19: Waveforms of the Vref- Vmean, Modulation Index and the
Irradiance
Time (t) sec
Figure 20: Waveforms of the Irradiance ,Mean Power, Voltage, Duty Cycle
Figure 21 : Waveforms of the Grid Voltage and Grid current
Figure 22 :Waveforms of the Grid Power
(b) Under Step Irradiance
In this case Irradiance is initially kept at 1000
W/m2 and changed to 200 W/m2 at t=0.5 sec. and again
step increased to 1000 W/m2 at t=0.7 sec.
© 2019, IRJET | Impact Factor value: 7.211 | ISO 9001:2008 Certified Journal | Page4654

Figure 24: Waveforms of the Vref-Vmean, Modulation Index and the
Irradiance
Figure 25 : Waveforms of the Irradiance Mean Power, Voltage, Duty Cycle
Figure 26 :Waveforms of the Grid Voltage and Grid current
Figure 27 : Waveforms of the Grid Power
VI. CONCLUSIONS
In this thesis, the study of the photovoltaic system
integrated with grid has been developed with maximum
power point controller. A Photovoltaic array is developed
in MATLAB Simulink model. The photovoltaic system with
DC-DC boost converter, maximum power point controller
and multilevel inverter has been designed and simulated
with Simulink MATLAB. System performance is examined
under different conditions and following points can be
concluded:
1. The multilevel inverter employed eliminates the need
of transformer because it can directly be connected to
high voltage sources, this means a reduction of
implementation and costs.
2. The multilevel inverter employed provides suitable
voltage with the right frequency and phase angle for
interconnection to the grid.
3. According to IEEE standard 929 power factor (>0.85)
and operating range of output voltage (106≤ V ≤ 132)
of PV is validated.
REFERENCES
1. J.M Carrasco et al., power electronics system for the
grid integration of Renewable energy soureces; A
Survey in IEEE Transactions on industrial electronics,
vol, 53. No,4pp1002-100`6june 2006
2. T.esram and P.L. Chapman, comparision of
photovoltaics Array Maximum power point tracking’s
techniques, in ieee transactions energy conversion,
vol.22,no. 2,pp. 439- 449,june 2007
3. Hung-Liang Cheng, Yao-Ching Hsieh and Chi-Sean Lin,
“A Novel Single-Stage High-Power-Factor AC/DC
Converter Featuring High Circuit Efficiency,” IEEE
Transactions ON Industrial Electronics, VOL. 58, NO. 2,
FEBRUARY 2011. PP (524-532).
4. Yu-Huei Lee, Shao-Chang Huang, Shih-Wei Wang, Wei-
Chan Wu, Ping-Ching Huang, Hsin-Hsin Ho, Yuan-Tai
Lai and Ke-HorngChen,“Power-Tracking Embedded
Buck–Boost Converter With Fast Dynamic Voltage
Scaling for the SoC System,” IEEE Transactions on
Power Electronics, VOL. 27, NO.3, MARCH 2012. PP
(1271-1282).
5. Hossein Nasiri Avanaki; Reza Barzegarkhoo; Elyas
Zamiri, A Switched-Capacitor Multilevel Inverter for
grid-connected PV systems with MPPT ability and
reduced components, 2018 9th Annual Power
Electronics, Drives Systems and Technologies
Conference (PEDSTC), Pages: 224 – 230.

IRJET- Cascaded Multilevel Inverter with MPPT for Grid Connected PV System

More Related Content

What's hot (20)

Similar to IRJET- Cascaded Multilevel Inverter with MPPT for Grid Connected PV System (20)

More from IRJET Journal (20)

Recently uploaded (20)

IRJET- Cascaded Multilevel Inverter with MPPT for Grid Connected PV System