Sprocket side stand retrieve system ppt
- 1. SPROCKET SIDE-STAND RETRIEVE SYSTEM INTRODUCTION In modern world the living status were developed and developing more equipped. The automobile takes a great part in the development, since it plays one of a major key in daily life. while automobile is concern two-wheeler i.e(motorcycles and bike) it plays very important role because it saves the time of traveler by reaching the target place very faster. Although it saves the time it does not safe the life of rider if rider is careless.
- 2. SOURCE FOR ACCIDENTS • While the two-wheelers is concerned accidents occurs due to riding the vehicle in high speed, ignores to use helmets, does not maintains the speed limit and forgets to lift the side stand while riding the vehicles. These are the major source for accidents. •Forgetting to lift the side stand causes huge accidents in rural areas partly in urban areas too, but accident due to side stand do not have proper preventive measure. If you see the accident status 36% of the accidents occur due to this problem. S.NO DURING THE YEAR REASON FOR THE ACCIDENT %OF ACCIDENTS 1. 2008-2012 Forgetting to lift side-stand 36% 2. 2008-2012 Does not maintain speed limit 38% 3. 2008-2012 Does not obey traffic rules 22% 4. 2008-2012 Other problems 04%
- 3. PROPOSED METHOD SPROCKET SIDE-STAND RETRIEVE SYSTEM Based on the working principle of two-wheeler ( i.e the power is generated in the engine and it transmits power to the pinion and makes it to rotate. The pinion transmits power to the rear wheel pinion and makes the vehicle to move). This is the basic principle followed in all type of two-wheelers, based on this “SPROCKET SIDE STAND RETRIVAL SYSTEM” is designed because this system works by getting power from chain drive. This sprocket system consists of four components Axle Sprocket pinion Lifting lever Pushing lever
- 4. axle with key way Sprocket with bearing
- 5. Lifting lever Pushing lever
- 6. WORKING PROCESS Sprocket side stand retrieve system retrieves the side stand automatically if the rider forgets to lift the side stand while moving the bike. It works based on the working principle of the two-wheelers. Every bikes transmit power from engine’s pinion to the rear wheel i.e. rotary motion of the pinion makes the linear motion of the chain. that linear motion of the chain is absorbed by rear wheel’s sprocket and converted into rotary motion. That rotary motion of the rear wheel makes the bikes to move. Based on this Sprocket side stand retrieve system is designed.
- 7. AT RESTING CONDITION
- 9. RETRIVED CONDITION
- 10. CONCLUSION “ Sprocket- side stand retrieve system” will definitely good retrieve system. since the setup is compact it does not affect the performance of the vehicle. because of the power is obtained from chain drive. Definitely this system could be used in all type of two-wheelers (Tvs-XL, all front, back, hand geared) for retrieving the side stand. These system can be implemented in all types of bikes by changing small variation in size and cost of this system also very low and so it will not affect the economic level also, while compare to other system this SPROCKET SIDE STAND RETRIEVE SYSTEM will be the life saver
- 11. COST ANALYSIS MATERIAL COST SPROCKET 2 NOS 300*2= 600RS LARGER SPROCKET 1NOS 800RS WHEEL CHAIN 500RS SIDE STAND WITH 450RS BOLT&SPRING MSRODS(FRAME,LIFTING&PUSH 1200RS ING LEVER) PEDAL 200RS TOTAL 3800RS